20
RQT6085
Cassette deck operations
1
2
3
4
A
4
1
•
3
2
DECK 1/2
DEMO
TAPE
OPEN
DECK 1
TAPE
DECK 1/2
VOL
DO
WN
UP
OPEN
DECK 2
Listening to tapes
You can use either deck 1 or deck 2 for tape playback.
Use normal position tapes.
High position and metal position tapes can be played, but the unit will
not be able to do full justice to the characteristics of these tapes.
1
Press [TAPE
:
].
The unit will come on automatically.
If the unit was off and a cassette was loaded, play will start
automatically (One touch play function).
2
Press [
c
DECK 1 OPEN] or [
c
DECK 2
OPEN] and insert the tape.
Insert the tape with the exposed tape facing down.
Close the holder by hand.
3
Press [TAPE
:
] to start playback.
One side is played, then playback stops automatically.
To play on the other side of the tape, turn the tape over and
press [TAPE
:
].
4
Adjust the volume.
To stop tape playback
Press [
L
/–DEMO].
Fast-forward and rewind
Press [
g
/REW/
4
] (rewind) or [
3
/FF/
f
] (fast-forward).
A
To change the deck to be used
Press [DECK 1/2] to select the deck you want to use when you
load cassettes into both decks.
You can also use remote control to perform by pressing [PLAY
MODE].
Notes
•
Playback is momentarily interrupted while playing back tapes, if you
open the other deck.
•
Tapes exceeding 100 minutes are thin and can break or get caught
in the mechanism.
•
Tape slack can get caught up in the mechanism and should be
taken up before the tape is played.
•
Failure to operate endless tapes correctly may cause the tape to
wind around the revolving parts. Always read the instructions pro-
vided with your tapes.
Front side
