16
8 Troubleshooting Guide
8.1. About Operation of Set
The images from this unit do not appear on
the TV.
Picture is distorted.
Jittering occurs.
¾
The “Resolution” setting is incorrect or the
“TV System” setting of the unit and that of the
TV do not match.
L
Restore the default settings
.
¾
PAL discs cannot be correctly viewed on an
NTSC TV.
¾
If irregular colouring occurs on your TV, turn
the TV off for about 30 minutes.
If it persists, move the speakers further away
from the TV.
Picture
Distorted sound or noise is heard.
¾
Adjust the position of the antenna.
A beat sound is heard.
¾
Try to keep a certain amount of distance
between the antenna and the TV.
Error Disc
¾
You inserted an incompatible disc.
¾
The disc may be upside down.
This operation is not available.
¾
Some operations are unsupported by the unit.
This list only contains displays that are difficult to read.
Radio
Messages on the screen
Unit’s display list
Display
Reading
Display
Reading
OFF
OPEN
LOAD
MUTE
STOP
SETUP
DISC
USB
AUX
ERASE
UPD (Update)
DONE
ERR (Error)
No DISC,
No PLAY,
No READ,
UNSUPPORT
No sound.
Low volume.
Distorted sound.
Cannot hear the desired audio type.
¾
Depending on the connected equipment, the
sound may be distorted if this unit is
connected with an HDMI cable.
Disc cannot be played.
¾
The disc is dirty.
Alternative subtitles cannot be selected.
¾
You may not be able to use the Option menu
to change the subtitles on some discs. Use
the disc’s menus to make changes.
Sound
Playback
w
To return to the factory defaults.
¾
Select “Restore” in “Default” in the Setup
menu.
To return all settings to the factory preset.
¾
Reset the unit as follows:
Turn the unit on.
Press [
] to open the disc tray.
Press and hold [
w
] and [
/
] on the main
unit at the same time for more than
5 seconds.
You have forgotten your ratings password.
You want to cancel the ratings level.
¾
The ratings level returns to the factory defaults.
L
Restore the default settings following the
steps described in “To return all settings to
the factory preset.”. (
>
above)
This unit does not recognize the USB
connection correctly.
¾
Disconnect and re-connect the USB cable. If
it still does not recognize the connection, turn
this unit off and on again.
¾
USB devices may not be recognized by this
unit when connected using the following :
L
a USB hub
L
a USB extension cable
¾
If you connect USB HDD to this unit, use the
USB cable that is supplied with the HDD.
General operation
