Panasonic SA-HT830VP, Руководство по обслуживанию

Страница: 18 / 157

<Additional data 3> (Mechanical process transition NO)
(EJECT) (P ON)
10 : PLAY
→
REV passing11 : REV passing12 : REV
passing → LOAD
(Capstan stop)13 : LOAD
→
DOWN14 : DOWN
→
EJECT15
: EJECT completed
None displayed: Power ON treatment
(P OFF)
70 : PLAY
→ P OFF
(FF) (REW)
U0 : PLAY
→
STOP FU1 : STOP F
→
FFU2 : FF initialization A0 : PLAY
→
STOP FA1 : STOP F
→
REWA2 : REW
initialization
(PLAY) (STILL)
20 : Cylinder initialization, phase drawing21 : Audio mute, W
switch 40 : Forward rotation, REC signal off41 : Speed 0, Capstan
Off
(REC) (STILL → PLAY)
30 : Cylinder initialization, phase drawing31 : REC signal
output 48 : Tape forwarding
(CUE → PLAY) (REV)
4A : End terminal check, tape forwarding4- : PLAY check,
tape forwarding 80 : PLAY → P OFF81 : Rewind82 : P OFF → REV
(CUE)
49 : Double speed forwarding, remaining computation jump
<Additional data 4> (LM information)
By loading motor driving request
No change in mechanical position: 1 (loading motor OFF)
Some change in mechanical position: 2 (loading motor ON)
10.2. Self-Diagnosis Function (DVD Section)
10.2.1. Self-Diagnosis Display
<Overview>
The details of failures detected in circuit or mechanism by the microcomputer will be automatically displayed on the FL display
as the result of self diagnosis.
<Setting>
1. Power-up the unit.
2. Set to “DVD/CD” mode using [INPUT SELECTOR] button on main or [DVD] button on the remote control (Ensure no disc
is placed in the tray.)
3. Press & hold [STOP] button on main unit follow by [INPUT SELECTOR] for 2s. It enters into self-diagnostic mode.
4. Press [POWER] on main unit to exit this mode.
5. Press [STOP] to display if there is other error codes.
The details of a failure applicable to an error code will be displayed on the FL display.
<Display>
FL display example: [----T--H05]
<List of Error Code>
Display Type of error Description
U 11 Focus error
H 01 Tray loading error
H 02 Spindle servo error Spindle servo, DSC, SP motor, CLV servo error
H 03 Traverse motor error
H 04 Tracking servo error
H 05 SEEK time-out error
H 15 Open SW error It is memorized if there is abnormal SW while operating, and is fail-save operation, and an abnormal
content is displayed by the self-diagnostic mode usually.
Abnormal SW is detected in the abnormal detection mode.
H 16 Close SW error
18
SA-HT830VP / SA-HT830VPC