5
Connecting a Bluetooth
®
device
1
In the power-off state, press and hold the
power button of this unit for approx.
3 seconds until the LED (blue) blinks
•
A beep will sound, and the LED (blue) on the remote
controller will blink slowly.
Power
LED
To turn the power off
•
Press and hold for approximately 3 seconds.
A beep will sound and the power will be turned off.
■
Note
•
When the unit is not operated for approximately 5 minutes, the power will
automatically turn off. (See “Auto power off” (→ P. 7))
Turning the power on/off
Preparation
•
Place the Bluetooth
®
device within approx. 1 m from the unit.
•
Check the device operation using its operation instructions as required.
Pairing (Registration) this unit with the Bluetooth
®
device for
connection
1
In the power-off state, press and hold the power button of this
unit until the LED blinks
When pairing a device for the first time
: approx. 3 seconds
When pairing a second or subsequent devices : approx. 5 seconds
•
The unit starts to search for the Bluetooth
®
device for connection, and the
LED will blink in blue and red alternately.
2
Turn on the power of the Bluetooth
®
unit, and enable the
Bluetooth
®
function
3
Select “RP-BTS10” from the
Bluetooth
®
device’s menu
• The MAC address “□□□□□□” (“□”
stands for a character that is unique
to each set.) may be displayed
before “RP-BTS10” is displayed.
•
If prompted for a passkey, input the
passkey “0000 (four zeros)” of this
unit.
Bluetooth
Bluetooth
RP-BTS10
Device
ON
Select
(Ex.)
4
Check the connection with the
Bluetooth
®
device on the unit
•
The LED will blink in blue and red
alternately until the connection with
the device is completed. When an
electronic sound beeps and the LED
(blue) blinks twice every approx.
2 seconds, pairing (registration) is
completed. (Connection established)
■
Note
•
If connection to a device is not established within approximately 5 minutes, the
unit will be turned off. Perform pairing again.
•
You can pair up to 8 Bluetooth
®
devices with this unit. If a 9th device is paired,
the device with the oldest connection will be replaced. To use it, perform pairing
again.
How to wear the earphones
Hung this unit around the neck with the remote controller on the right side, and put
on the earphones.
Move the cord adjuster toward the back of the head, and adjust the cord length.
Cord adjuster
Clip
■
Note
•
When using the earphones for the first time, slide the clip to achieve a
comfortable fit, and adjust the clip to the position where sounds are most easily
heard.
•
Depending on the wearing condition, sound quality may change.
■
Attension
•
Do not forcibly deform the clip.
The clip may be damaged.
