Panasonic RP-BT10-W, Руководство по эксплуатации

Страница: 24 / 32

RQT8993
24 25
RQT8993
Maintenance
The unit (receiver) uses a rechargeable nickel metal hydride battery. (RP-BP65HP-1)
To protect the environment and conserve valuable resources, when disposing of the unit, remove its rechargeable
nickel metal hydride battery and take it to a recycling center.
To clean this unit, wipe with a soft, dry cloth.
• Never use alcohol, paint thinner, or benzine to clean this unit.
• Before using chemically treated cloth, read the instructions that came with the cloth carefully.
How to dispose of the unit and battery
How to remove the battery
• When the rechargeable battery is to be replaced, consult with your dealer.
Use a screwdriver to undo the screw on the back panel of the
unit (receiver), and remove the battery lid.
Remove the rechargeable battery.
Caution:
• Unless the unit is to be disposed of, do not remove the battery lid.
• Check that the rechargeable battery has completely discharged
before removing it.
■
Troubleshooting
Before requesting service, make the below checks. If you are in doubt about some of the check points, or if the
remedies indicated in the chart do not solve the problem: refer to the “Panasonic / Technics Accessory Limited
Warranty” on page 29. Take the unit when you visit your dealer.
Problem Possible cause and suggested remedy
I can’t hear any sound.
The sound is barely
audible.
I hear a lot of noise.
The sound keeps breaking
up.
• Something is wrong with the wireless communication.
• Is power being supplied to the unit and device connected to it? (Is the unit’s lamp
blinking in blue?)
•Have you temporarily suspended play using the receiver or iPod ® ?
• Has the transmitter been inserted all the way into the docking connector of the iPod ® ?
• Is the transmitter’s connector dirty?
• Has the input plug of the stereo earphones been inserted all the way (into the
AUDIO OUT connector)?
• Is the plug dirty?
• Noise may be heard due to the effect of the cellphone.
• Depending on the specifications and settings of your cellphone, the sound may break
up or data communication may not be possible when you operate your cellphone.
• Is a Bluetooth -enabled device other than this unit being used? Do not use the two
devices at the same time.
The unit doesn’t work.
• Has the battery in the receiver or the device connected discharged? If it is, recharge it.
• No power is supplied while the unit is being charged.
• Connect the transmitter firmly to your iPod
®
, and reset the receiver. (The pairing
information is not erased by this operation.) Then perform the pair setting again.
* Reset operation: Insert a paper clip or other thin rod-type object into the hole on
the receiver and press until there is the feeling of a button being pressed.
I can’t register the (pairing
of the) device.
• Did you allow more than one minute to elapse after setting the unit to the device
registration mode? The pair setting is automatically released if you allow more than
one minute to elapse.
• Set the pairing with the unit and connected device placed as close to each other as possible.
I can’t use my cellphone
to communicate.
• Is your cellphone set to auto response or answering machine mode?
• Have you set the volume level for the incoming tone and for receiving calls too low?