Panasonic QuintrixF TX-28PK25, Руководство по обслуживанию

Страница: 5 / 40

ADJUSTMENT PROCEDURE
Item / Preparation Adjustments
+B SET-UP
1. Receive a Greyscale signal.
2. Set the controls :-
Brightness Minimum
Contrast Minimum
Volume Minimum
1. Set the +B voltage up as follows:-
Adjust R811 so that B2 shows 148V±1V.
2. Confirm the following voltages.
B9 5 ± 0,25V B10 5 ± 0,25V
B5 12 ± 0,5V B11 33 ± 1,5V
B4 15 ± 1V B7 8 ± 0,5V
B12 26 ± 2V B8 6 ± 1V
B3 36 ± 1,5V B13 13 ± 1V
B1 205 ± 10V B14 14 ± 1V
CUT OFF / Ug2 Test
1. Receive a Greyscale signal.
2. Degauss the tube externally.
3. Set the TV into Service Mode 1.
4. Select Cut off mode.
To adjust Cutoff connect an oscilloscope to the Blue
cathode. Press "STR" and adjust "cutoff" value using the
"Yellow" and "Blue" buttons until the black level is 160V±5V,
press "STR" to store the value. Remove the oscilloscope.
Select Ug2 adjustment and adjust the screen VR until the
display shows "O.K."
FACTORY SETTINGS
Self-check is used to automatically check the bus lines and hexadecimal code of the TV set. To get in to Self-Check mode
press the down (-/v) button on the customer controls at the front of the TV set, at the same time pressing the STATUS button
on the remote control.
If the CCU ports have been checked and found to be incorrect or not located then " - - " will appear in place of "O.K.".
4
PCB O.K.
CAB O.K.
TX- 28PK25
OPTION1 00
OPTION2 A1
OPTION3 02
OPTION4 C0
OPTION5 B1
OPTION6 E1
VPC O.K.
SRC O.K.
DDP O.K.
TUN O.K.
E2 O.K.
MSP O.K.
DPL - -
To exit Self Check, switch off the TV set at the power button.
All manuals and user guides at all-guides.com