Panasonic PT-VX610, Руководство по эксплуатации

Страница: 80 / 134

Note
f
The projector can consume less power, extend the luminous lamp life longer and produce less operation noise when set from [NORMAL] to
[ECO1] or from [ECO1] to [ECO2].
f
[LAMP POWER] cannot be set when the test pattern is displayed.
[ECO MANAGEMENT]
This function optimizes the luminous lamp power according to the operating status and reduces power
consumption.
Setting [AUTO POWER SAVE]
Set whether or not to enable the three functions, [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION] and
[AV MUTE DETECTION].
1) Press
as
to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f
The [ECO MANAGEMENT] screen is displayed.
3) Press
as
to select the [AUTO POWER SAVE].
4) Press
qw
to switch the [AUTO POWER SAVE].
[ON] Enables the energy conservation setting.
[OFF] Disables the energy conservation setting.
5) Press
as
to select one item.
[AMBIENT LIGHT
DETECTION]
Adjusts the power of the luminous lamp according to the brightness of the installation location.
[SIGNAL DETECTION]
Lowers the power of the luminous lamp when there is no signal.
[AV MUTE DETECTION] Lowers the power of the luminous lamp in AV mute.
6) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[ON] Enables above setting.
[OFF] Disables above setting.
Note
f
The lamp power cannot decrease automatically in the following cases:
g
When the luminous lamp is just turned on or [LAMP POWER] is just set
f
When [AUTO POWER SAVE] is set to [OFF], settings of [AMBIENT LIGHT DETECTION], [SIGNAL DETECTION], [AV MUTE DETECTION]
are unavailable.
f
When objects, etc. are placed on top of the projector, the luminance sensor may be blocked, therefore the brightness cannot be detected
correctly. The projector may not work properly even [AMBIENT LIGHT DETECTION] is set to [ON].
Setting [POWER MANAGEMENT]
Set the operation of the power management function when there is no signal input for a certain period of time.
1) Press
as
to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f
The [ECO MANAGEMENT] screen is displayed.
3) Press
as
to select [POWER MANAGEMENT].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[SHUT DOWN]
The countdown timer is displayed after 30 seconds without input signal. The luminous lamp turns off
and cools down when the time set in [TIMER] has elapsed, then the projector enters into standby
status.
[OFF] Power management function is off.
[READY]
The countdown timer is displayed after 30 seconds without input signal. The luminous lamp will turn
off and enter into standby status after cooling down when the time set in [TIMER] has elapsed. The
luminous lamp will be turned on and enter into projection state if any signal is input or any button is
pressed during standby mode.
80 - ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu