Panasonic PT-VMZ50, Руководство по эксплуатации, Страница: 96 / 150

[HDCP STATUS]
The content of display is as follows.
[ON]: When protected with HDCP
[OFF]: When not protected with HDCP
[NO SIGNAL]: When there is no signal
[SIGNAL QUALITY]
[SIGNAL QUALITY] is a numerical value of the amount of error, and the display color changes to
green, yellow, or red depending on that value.
Check the signal quality level while receiving a signal from the twisted-pair-cable transmitter.
f
[MAX]/[MIN]: Maximum/minimum value of the amount of error.
f
Green (- 12 dB or lower) → Normal signal quality level.
f
Yellow (- 11 to - 8 dB) → Warning level where there is the possibility of noise introduced on the
screen.
f
Red (- 7 dB or higher) → Abnormal level where synchronization may be interrupted or a signal may
not be received.
[DIGITAL LINK MENU]
(Not available for PT-VMZ40)
When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected
to the <DIGITAL LINK/LAN> terminal, the main menu of the connected DIGITAL LINK output supported device is
displayed. Refer to the Operating Instructions of the DIGITAL LINK output supported device for details.
Note
f
[DIGITAL LINK MENU] cannot be selected when the [NETWORK] menu → [NETWORK CONTROL] → [EXTRON XTP] is set to [ON].
[WIRED LAN]
Perform the connection settings to use wired LAN.
1) Press
as
to select [WIRED LAN].
2) Press the <ENTER> button.
f
The [WIRED DETAILED SETUP] screen is displayed.
3) Press
asqw
to select an item, and change the setting according to the menu operation instructions.
[DHCP]
[ON]
Set when a DHCP server exists in the network to which the
projector is connected and the IP address is obtained automatically.
[OFF]
Set when a DHCP server does not exist in the network to which the
projector is connected and you need to specify the IP address.
[IP ADDRESS]
Enter the IP address when [DHCP] is set to [OFF].
[SUBNET MASK] Enter the subnet mask when [DHCP] is set to [OFF].
[DEFAULT GATEWAY] Enter the default gateway address when [DHCP] is set to [OFF].
[DNS1] Enter the preferred DNS server address when [DHCP] is set to [OFF].
[DNS2] Enter the alternate DNS server address when [DHCP] is set to [OFF].
4) After the setting, select [OK] and press the <ENTER> button.
Note
f
For the setting content of each item, consult your network administrator.
f
The network setting is common for the <LAN> terminal and the <DIGITAL LINK/LAN> terminal.
f
Wired LAN and wireless LAN cannot be used in the same segment.
f
When using the projector with [DHCP] set to [ON], confirm that the DHCP server is running.
r
Factory default settings
f
Following setting has been made as a factory default.
[DHCP] [OFF]
[IP ADDRESS] 192.168.10.100
[SUBNET MASK] 255.255.255.0
[DEFAULT GATEWAY]
192.168.10.1
[DNS1] / [DNS2] (Blank)
[PROJECTOR NAME]
You can change the projector name. Enter the host name if it is required to use a DHCP server.
1) Press
as
to select [PROJECTOR NAME].
96 - ENGLISH
Chapter 4 Settings - [NETWORK] menu