Panasonic PT-TW371R, Руководство по эксплуатации

Страница: 93 / 114

ENGLISH - 93
Power/Warning Indicators
If a problem should occur inside the projector, the power indicator <ON(G)/STANDBY(R)> and the warning indicator
<WARNING> will inform you by lighting or blinking. Check the status of the indicators and remedy the indicated problems as
follows.
Attention
f
Before you take a remedial measure, follow the procedure of switching the power off indicated in “Powering Off the
Projector” (
x
page 38).
Power indicator <ON(G)/STANDBY(R)>
Warning indicator <WARNING>
Power indicator
<ON(G)/STANDBY(R)>
Warning
indicator
<WARNING>
Status Cause Solution
Off Off
The power plug is not
connected to the outlet.
--
Connect the power plug
to an outlet.
Red
Blinking Lighting in red
It has reached the re-
placement time of the
lamp unit.
f
The indicator lights up
when the usage time of
the lamp unit reaches
20 000 hours (when
[Lamp control] is set to
[ (Eco)]).
f
Replace the lamp unit.
Blinking Blinking in red
It has exceeded the
replacement time of the
lamp unit and the projec-
tor is turned off automati-
cally.
f
The indicator blinks
when the usage time of
the lamp unit reaches
22 000 hours (when
[Lamp control] is set to
[ (Eco)]).
Green
Lighting Lighting in red
The replacement time
of the lamp unit is dis-
played. (Projecting)
f
Is the lamp replacement
warning icon
displayed
when turn on or turn off
the projector?
f
The indicator lights up
when the usage time of
the lamp unit reaches
20 000 hours (when
[Lamp control] is set to
[ (Eco)]).
f
Replace the lamp unit.
Lighting Blinking in red
It has exceeded the
replacement time of the
lamp unit and the projec-
tor is turned off automati-
cally.
f
The indicator blinks
when the usage time of
the lamp unit reaches
22 000 hours (when
[Lamp control] is set to
[ (Eco)]).
Blinking Off
The power cord is
plugged and the lamp is
turned off. (Ready state)
f
[Power management] is set to [Ready].
If a video signal is input in Ready mode, or when
you press any button other than the power
<
v
/
b
> button, the luminous lamp turns on and the
projector enters the projection state. Pressing the
power <
v
/
b
> button during the Ready state will
enter the standby state. (
x
page 70)
Chapter 6 Maintenance - Power/Warning Indicators