Panasonic PT-RZ470EAW, Руководство по эксплуатации

Страница: 77 / 138

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 77
[COOLING CONDITION]
Change the fan control depending on the direction of projection.
Set [COOLING CONDITION] correctly in accordance with the direction of projection referencing the following figure. Using the light source with
incorrect settings may shorten its life.
15°
15°
15°
15°
：
30°
30° 30°
30°
[VERTICAL UP SETTING]
[FLOOR
SETTING]
[CEILING
SETTING]
[VERTICAL DOWN SETTING]
[PORTRAIT SETTING]
Projection direction
Frontward: Projection direction
[FLOOR SETTING]
[CEILING SETTING]
1) Press
as
to select [COOLING CONDITION].
2) Press the <ENTER> button.
f
The [COOLING CONDITION] screen is displayed.
3) Press
as
to select a cooling condition.
4) Press the <ENTER> button.
5) When the confirmation is displayed, select [OK] or [CANCEL], and press the <ENTER> button.
[ECO MANAGEMENT]
A function that optimizes the light source power to suit usage conditions to reduce power consumption.
Setting [LIGHT POWER]
1) Press
as
to select [ECO MANAGEMENT].
2) Press the <ENTER> button.
f
The [ECO MANAGEMENT] screen is displayed.
3) Press
as
to select [LIGHT POWER].
4) Press
qw
to switch [LIGHT POWER].
f
The items will switch each time you press the button.
[NORMAL] Sets when high luminance is required.
[ECO SAVE1]
Reduces the power by approximately 20 % in average compared to [NORMAL] without affecting the
brightness.
[ECO SAVE2]
Reduces the power by approximately 30 % in average compared to [NORMAL], minimizing reduction
in brightness.
[LOW] Sets this when you want to save more power without the need for high brightness.
Note
f
The rate of power consumption reduction when the eco save mode is set refers to the ratio of average power consumption when a
“Broadcast” video signal that complies with IEC62087 is projected.
f
When [ECO SAVE1] and [ECO SAVE2] is set, the image may appear differently to [NORMAL].
f
If you feel that the brightness has decreased with [ECO SAVE2], switching to [ECO SAVE1] may improve the image.
f
When [LOW] is set, the operating noise can be reduced.
f
When the VIDEO input is selected, [ECO SAVE1] and [ECO SAVE2] cannot be selected. When [ECO SAVE1] or [ECO SAVE2] is set while
selecting other than VIDEO input, and when the VIDEO input is selected, [LOW] is set.
f
When [NATURAL] is selected in [PICTURE MODE], and [ECO SAVE1] or [ECO SAVE2] is selected in [LIGHT POWER], the image may not
conform to sRGB standards.
f
When [REC709] is selected in [PICTURE MODE], and [ECO SAVE1] or [ECO SAVE2] is selected in [LIGHT POWER], the image may not
conform to Rec.709 standards.
f
When [DICOM SIM.] is selected in [PICTURE MODE], and [ECO SAVE1] or [ECO SAVE2] is selected in [LIGHT POWER], the image may
appear different from the image of DICOM standards.
f
Cannot be selected when viewing 3D videos. This is fixed to [NORMAL].