Panasonic PT-REZ12, Руководство по эксплуатации

Страница: 181 / 313

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 181
[REMOTE2 MODE]
You can set the <REMOTE 2 IN> terminal.
1) Press
as
to select [REMOTE2 MODE].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[DEFAULT] Uses pin assignment of the <REMOTE 2 IN> terminal in standard setting. (
x
page 288)
[USER] Changes the setting of the <REMOTE 2 IN> terminal.
f
Proceed to Step 3) when [USER] is selected.
3) Press the <ENTER> button.
4) Press
as
to select one from [PIN2] to [PIN8], and press
qw
to switch the setting.
[FUNCTION BUTTON]
Set the function of the <FUNCTION> button on the remote control.
1) Press
as
to select [FUNCTION BUTTON].
2) Press the <ENTER> button.
f
The [FUNCTION BUTTON] screen is displayed.
3) Press
as
to select a function.
[DISABLE] Disables the <FUNCTION> button.
[SUB MEMORY] Displays the sub memory list. (
x
page 197)
[SYSTEM SELECTOR]
Switches the [SYSTEM SELECTOR] setting according to the input signal of the image being
projected.
f
When the input is SDI
g
The [DISPLAY OPTION] menu
→
[SLOT IN]
→
[SYSTEM SELECTOR]
f
When the input is SDI OPT1 / SDI OPT2 of Function Board
g
The [DISPLAY OPTION] menu
→
[SLOT IN]
→
[SDI OPT1] / [SDI OPT2]
→
[SYSTEM
SELECTOR]
f
When the input is anything other than SDI / SDI OPT1 / SDI OPT2
The [PICTURE] menu
→ [SYSTEM SELECTOR]
[SYSTEM DAYLIGHT VIEW] Switches the [SYSTEM DAYLIGHT VIEW] setting. (
x
page 102)
[FREEZE]
Temporarily pauses the image. (
x
page 148)
[WAVEFORM MONITOR]
Displays the waveform of the input signal. (
x
page 149)
[LENS MEMORY LOAD]
Loads the registered lens memory. (
x
page 153)
[ASPECT] Switch the aspect ratio of the image. (
x
page 108)
[PROJECTION METHOD]
Switches the [PROJECTION METHOD] setting. (
x
page 151)
[GEOMETRY]
Switches the [GEOMETRY] setting. (
x
page 110)
[ANGLE MONITOR] Displays the [ANGLE MONITOR] screen. (
x
page 185)
4) Press the <ENTER> button.
Note
f
The [FUNCTION BUTTON] screen can also be displayed by holding down the <FUNCTION> button on the remote control.
[STATUS]
Display the status of the projector.
1) Press
as
to select [STATUS].
2) Press the <ENTER> button.
f
The [STATUS] screen is displayed.
3) Press
qw
to switch the pages.
f
The page will change each time you press the button.