Panasonic PT-REZ12, Руководство по эксплуатации

Страница: 179 / 313

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 179
f
The shutter operation by the shutter synchronization function will follow the setting of the [DISPLAY OPTION] menu → [SHUTTER
SETTING] on the projector that [MODE] is set to [MAIN].
f
When the input signal to each linked projector is not synchronized, the timing of the shutter operation between the projectors may shift up to
1 frame while using the shutter synchronization function.
f
The shutter function of the projector with [MODE] set to [SUB] can be operated individually. The shutter operation at this time will follow the
setting of the [DISPLAY OPTION] menu → [SHUTTER SETTING] set in that projector.
[TERMINAL SELECT]
Set the terminals to be used when the contrast synchronization function or the shutter synchronization function is
used.
1) Press
as
to select [MULTI PROJECTOR SYNC].
2) Press the <ENTER> button.
f
The [MULTI PROJECTOR SYNC] screen is displayed.
3) Press
as
to select [TERMINAL SELECT].
4) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[BNC] Uses the <MULTI SYNC IN> / <MULTI SYNC OUT> terminals (BNC).
[SERIAL] Uses the <SERIAL IN> / <SERIAL OUT> terminals.
Note
f
[BNC] and [SERIAL] cannot be used simultaneously within the linked projectors.
[RS-232C]
Set the communication conditions of the <SERIAL IN> / <SERIAL OUT> terminals. For details on the connection
method for RS-232C communication, refer to “<SERIAL IN> / <SERIAL OUT> terminal” (
x
page 284).
Setting the communication condition of the <SERIAL IN> terminal
1) Press
as
to select [RS-232C].
2) Press the <ENTER> button.
f
The [RS-232C] screen is displayed.
f
Proceed to Step 5) unless the optional DIGITAL LINK Terminal Board (Model No.: TY-SB01DL) or the
Function Board by other manufacturers is installed in the slot.
3) Press
as
to select [INPUT SELECT].
4) Press
qw
to switch the item.
[PROJECTOR] Performs the RS-232C communication with the <SERIAL IN> terminal of the projector.
[DIGITAL LINK]
Performs the RS-232C communication via the optional DIGITAL LINK output supported device (Model
No.: ET-YFB100G, ET-YFB200G) and the <DIGITAL LINK IN/LAN> terminal of the optional DIGITAL
LINK Terminal Board (Model No.: TY-SB01DL) installed in the slot.
[SLOT] Performs communication via the Function Board by other manufacturers installed in the slot.
5) Press
as
to select [(IN) BAUDRATE].
6) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[9600]
Select the proper speed. [19200]
[38400]
7) Press
as
to select [(IN) PARITY].
8) Press
qw
to switch the item.
f
The items will switch each time you press the button.