Panasonic PT-RCQ80, Руководство по эксплуатации

Страница: 69 / 265

Chapter 3 Basic Operations — Switching on/off the projector
ENGLISH - 69
Relationship between brightness and runtime
The projector can be operated with arbitrary brightness and runtime by setting [LIGHT OUTPUT] to desired
setting.
The relationship between the [LIGHT OUTPUT] setting, brightness, and the estimated runtime is as follows. Make
the initial setting (operation setting) depending on the desired brightness of the projected image and runtime.
The values of the brightness and the runtime are just an estimate, and the graph indicating the relationship is just
an example. Also, these do not indicate the warranty period.
r
PT-RCQ10
[LIGHT OUTPUT] (%) Brightness (lm) Estimated runtime
*1
(hours)
100.0 10 000 20 000
78.2 7 800 27 000
58.5 5 800 34 000
50.0 5 000 37 000
*1 Estimated runtime is the time until the brightness decreases to approximately half of the time of delivery when the projector is used with the
[PICTURE] menu → [DYNAMIC CONTRAST] set to [3] and under environment of 0.15 mg/m
3
dust.
[LIGHT OUTPUT] (%)
Brightness (lm)
Estimated runtime (hours)
20 000
50.0
70.0
90.0
40.0
60.0
80.0
100.0
26 800 30 200 33 600 23 400 37 000
10 000
5 000
r
PT-RCQ80
[LIGHT OUTPUT] (%) Brightness (lm) Estimated runtime
*1
(hours)
100.0 8 000 20 000
78.2 6 200 27 000
58.5 4 600 34 000
50.0 4 000 37 000
*1 Estimated runtime is the time until the brightness decreases to approximately half of the time of delivery when the projector is used with the
[PICTURE] menu → [DYNAMIC CONTRAST] set to [3] and under environment of 0.15 mg/m
3
dust.
[LIGHT OUTPUT] (%)
Brightness (lm)
Estimated runtime (hours)
20 000
50.0
70.0
90.0
40.0
60.0
80.0
100.0
26 800 30 200 33 600 23 400 37 000
8 000
4 000
Note
f
The runtime may be shorter than the estimation due to the influence of characteristics of each light source, conditions of use, installation
environment, etc.
f
If the consolidated runtime of the projector exceeds 20 000 hours, replacement of the components inside the projector may be required. The
consolidated runtime can be confirmed in the [STATUS] screen. Refer to the [PROJECTOR SETUP] menu → [STATUS] for details.
f
After completed the initial setting, the wider the combination of luminance and runtime becomes by setting the [PROJECTOR SETUP]
menu → [BRIGHTNESS CONTROL] → [BRIGHTNESS CONTROL SETUP] → [CONSTANT MODE] to [AUTO] or [PC]. Refer to the
[PROJECTOR SETUP] menu → [BRIGHTNESS CONTROL] for details.