Panasonic PT-D3500U Series, Руководство по обслуживанию

Страница: 20 / 93

6 Setting the Projector ID Number Remote Control
Every projector has its ID number and the ID number of the controlling projector must be set to the remote control in advance so
that the user can operate the remote control. The ID number of the projector is set to “ALL” on shipping, and use the ID ALL button
of the remote control when using only a single projector.
Procedure of ID setting
1. Change the position of the operation mode selector switch to “Computer”.
2. Press the ID SET button, and within five seconds use the numeric (0 to 9) buttons to enter the 2-digit ID number set by the
projector.
3. Change the position of the operation mode selector switch to “Projector”.
However, if the ID ALL button is pressed, the projector can be controlled regardless of the ID number of the projector
(simultaneous control mode).
· Do not press the ID SET button accidentally or carelessly because the ID number on the remote control can be set even
when no projector is around.
If the ID SET button is pressed, the ID number goes back to the one set before pressing the ID SET button unless a
numeric button is pressed within five seconds after the ID SET button is pressed.
·
Your specified ID number is stored in the remote control unit unless another one is specified later. However, the stored
ID will be erased if the batteries of the remote control are left exhausted. When the dry cells are replaced, set the same
ID number again.
·
When setting the ID number, the numeric buttons entering of two digits is required even if the 1-digit ID number is set
on the projector side.
For example, setting remote control ID when ID number of the projector is "1": Press the numeric buttons of "0" and "1"
within five seconds after the ID SET button is pressed.
20
PT-D3500U / PT-D3500E