Camera Housings & Mounting Hardware
111
TECHNICAL SPECIFICATIONS
®
7
The outdoor pressurized dome camera housing shall be a Panasonic model PPDW12 or equivalent. The housing
shall be designed for the Unitized Surveillance Device Series WV-CS654/CS404/BS304/BS504. The housing shall
be capable of withstanding a total of 5 psi of nitrogen gas injected through a Schraeder valve located on the
3
⁄
8
"
machined aluminum retaining ring. A pressure relief valve located next to the Schraeder valve will provide an
escape for pressure exceeding 5 psi. Two (2) o-ring seals shall be included, 0.136" x 12" (inner diameter) and
0.136" x 15" (inner diameter). A 10-pin hermetically sealed connector, located in the back of the pressurized
housing shall provide power, video and control functions. A stainless steel retaining cable will be used to
capture and hold the housing’s aluminum top during service. The housing shall be constructed of 0.090"
aluminum, UV stable ABS plastic, stainless steel and acrylic. The lower dome portion shall be constructed of
distortion-free cast acrylic (free blown) and be 12" in diameter. The housing shall include an integral 10-gauge
powder coated steel wall mount bracket. The housing shall include a camera mounting bracket that integrates a
heater, blower, video and power surge protector capable of clamping differential mode voltage between 24-36V
and common mode voltage from 54-72V. The housing shall be powered with 24VAC (60Hz) and have a power
consumption not to exceed 68W including Unitized Camera. The blower shall draw 1.4W continuous power. The
50W heater shall turn on at 40°F and turn off at 60°F. A ground isolation transformer, Panasonic model
PWBT1621, shall be available as an option . The housing shall support a temperature range of 20° to 120°F. The
unit shall have a weight not to exceed 18.5 lbs. (without camera) and dimensions of 14.9"H x 18.09"W x 18.25"D.
PPDW12 Pressurized Dome
Camera Housing
GENERAL SPECIFICATIONS
Construction
Pressurized enclosure
anodized aluminum
Top
0.090" 3003 aluminum
Dome
Cell cast acrylic
Wall Mount Bracket
10-gauge powder coated
steel
Sunshield
ABS plastic UV stable
Seals
2 o-rings: 0.136" x 12" (ID)
and 0.136" x 15" (ID); 2 types
of material
Pressure Relief Valve
5 psi
Schraeder Valve
Nitrogen input
Power Connector
10-pin Souriau, hermetically
sealed
Power Source
24VAC, 60Hz
Power Consumption
68W
Dimensions
14.9"H x 18.09"W x 18.25"D
Weight
18.5 lbs.
Weights and dimensions shown are approximate.
Specifications subject to change without notice.
ARCHITECTS’ AND ENGINEERS’ BID SPECIFICATIONS
