1
CONSOLE
9600.N.8.1(DTE)
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
SFP▲(17)
SFP▼(18)
SFP▲(19)
SFP▼(20)
SD CARD SLOT
POWER
STATUS
SD CARD
ZEQUO 2310
AC 100-240V
Part Names and Functions
2
Power cord hook block
If the supplied power cord is hanged to this block, the cord becomes hard to pull out
from the power port.
SD card slot
Insert an SD card into this slot to change/save settings and firmware.
10/100/1000BASE-T port (ports 1–20)
Devices such as 10/100/1000BASE-T terminal, hub, repeater, bridge, and Ethernet
Switch can be connected to this port . Install the device so that the length of twisted
pair cable (CAT5e or above) becomes 100 m or less.
SFP extension slot (ports 17-20)
Install SFP module. (It becomes exclusive usage with twisted pair port.)
When SFP extension slot is linked, the port is automatically switched to SFP extension
mode.
SFP port supports only the full duplex communication.
Console port
Connect a VT100 compatible terminal, etc. with this port to configure or manage this
Ethernet Switch.
Transmission mode : RS-232C
Transmission speed : 9,600 bps
Stop bit
: 1 bit
Flow control
: None
Emulation mode
: VT100
Data length
: 8 bits
Parity control
: None
Transmission connector : RJ45
Ground terminal
Only qualified personnel should install minimum 18AWG green-and-yellow stranded
copper wire to Ground terminal screw.
10BASE-T/100BASE-TX/1000BASE-T port
Console port
SD card slot
Front panel
SFP extension slot
MAC Address label
MAC Address label
Power cord hook block
Back panel
Serial number label
Serial number label
Ground terminal
Power port
Power port
Connect the supplied power cord to this port and connect the other end into an
electric outlet.
11
Communication mode on ports 17 to 20 support full-duplex mode only. Half-duplex
mode is not supported.
