36
Electronic Board Operations Check
After assembling the electronic board, perform the procedures presented in the following table to make sure it
functions properly.
Step
Points to Check
Symptom
Solutions
1
Turn on the power switch.
“ ” flashes after “ ” lights
up.
(Normal operation)
(If not)
Check power cord. (See step
16 on page 34.)
2
Open the printer door and load the
copy paper, then close the printer
door.
• Loading Copy Paper procedure
(refer to the Operating
Instructions on page 10)
“ ” lights up after the copy
paper is fed and
automatically cut.
(Normal operation)
(If not)
Check the condition of printer
door or copy paper roll.
3
Press .
Screen is fed.
(Normal operation)
The screen film surface is not
fed smoothly.
Contact the store or dealer
from which the unit was pur-
chased.
There are strange noises.
4
Use the accessory marker to
draw a large
filling the
entire copyable area of the
screen film surface.
•Copyable area (refer to the
Operating Instructions on
page 7)
Press
twice.
Press .
“ ” lights up and three
copies are made.
(Normal operation)
Three copies are not made.
Contact the store or dealer
from which the unit was pur-
chased.
The entire readable area is
not printed.
There are strange noises or
paper jams during the
copying process.
5
Press
to move the screen
film surface. Write letters, etc.
with the marker.
Press
once.
Press .
The Contrast indicator light is
turned on and one copy is
made.
(Normal operation)
The Contrast indicator light is
not turned on.
Contact the store or dealer
from which the unit was pur-
chased.
The image is not copied
properly.
There are strange markings
on the copy sheet (e.g.,
stripes or lines).
6
Press
once.
The Contrast indicator light is
turned off.
(Normal operation)
(If not)
Contact the store or dealer
from which the unit was pur-
chased.
7
Press .
Two screens are copied
properly.
(Normal operation)
(If not)
Contact the store or dealer
from which the unit was pur-
chased.
UB-5320_EN.book 36 ページ ２００８年１月１１日 金曜日 午前１０時３９分
