2.2.5. FLAT CARD CABLE INSTALLATION
When installing the Flat Card Cable on the connector, install the Flat Card Cable with the cable
contacts facing the connector contacts.
Fig. S8
2.3. REMOVAL OF CASSETTE TAPE
There are 2 ways to remove a cassette tape.
1. Service Information Display Operation
A. Turn the Shuttle Ring to FF and Press EJECT key
simultaneously for 3 seconds and set the Service Mode 7.
B. Press STOP key in order to rotate the Loading Motor for
unloading operation. (Pay an attention of tape slack)
2. Manual Operation
A. Disconnect the AC Mains Lead and remove the Top Panel.
B. Rotate the Main Cam Gear clockwise until the Loading Posts
move to fully unloaded position as shown in
Fig. S9
. (Tape is
remaining)
Содержание NV-HS860B-S
