Panasonic NV-GS55GC, Руководство по эксплуатации

Страница: 60 / 116

Before Use
-60-
ª
Using the Remote Controller
1
Direct the Remote Controller at the Remote
Control Sensor
(33) of the Movie Camera
and press an appropriate button.
≥
Distance from the Movie Camera: Within
approximately 5 metres
≥
Angle: Within approximately 15
o
in the
vertical and horizontal directions from the
central axis
≥
The above operating ranges are for indoor use.
Outdoors or under strong light, the Movie
Camera may not operate properly even within
the above ranges.
≥
Within a 1-metre range, you can also use the
Remote Controller on the LCD Monitor side of
the Movie Camera.
Selecting Remote Controller Modes
When 2 Movie Cameras are used
simultaneously, they can be operated individually
by selecting different Remote Controller Modes.
≥
If the Remote Controller Mode of the Movie
Camera and that of the Remote Controller do
not match, [REMOTE] Indication is displayed.
Setup on the Movie Camera:
Set [REMOTE] on the [INITIAL] Sub-Menu to the
desired Remote Controller Mode. (
-66-
)
Setup on the Remote Controller:
[VCR1]:
Press the [
D
] Button and [
∫
] Button
simultaneously. 1
[VCR2]:
Press the [
E
] Button and [
∫
] Button
simultaneously.
2
≥
When the battery in the Remote Controller is
replaced, the mode is automatically reset to
[VCR1] Mode.
15˚
15˚
15˚
15˚
(33)
INDEX INDEX
SELECT
STOP
K L
∫
STILL ADV
T
W
PAUSE STILL ADV
6 1 5
; E D
P.B. ZOOM
2 1
Power Supply
ª
Using the AC Adaptor
1
Connect the DC Input Lead to the Movie
Camera.
2
Connect the DC Input Lead to the AC
Adaptor.
3
Connect the AC Mains Lead to the AC
Adaptor and the AC mains socket.
≥
The AC Mains Lead’s outlet plug does not fit
entirely into the AC Adaptor socket. A gap will
remain as shown
1 .
≥
Before connecting or disconnecting the
power supply, set the [OFF/ON] Switch on
the Movie Camera to [OFF] and make sure
that Power Lamp is not lit.
ª
Using the Battery
Before use, fully charge the Battery.
≥
We recommend using Panasonic’s Battery.
≥
We cannot guarantee the quality of this Movie
Camera when batteries of other companies are
used.
1
Attach the Battery to the AC Adaptor and
charge it.
≥
Since the Battery will not be charged when
the DC Input Lead is connected to the AC
Adaptor, disconnect it from the AC Adaptor.
≥
The [CHARGE] Lamp lights up, and charging
starts.
≥
When the [CHARGE] Lamp goes off,
charging is completed.
≥
When charging the overdischarged battery,
the [CHARGE] lamp blinks at first, but the
battery is charged normally. When the
temperature of the battery is too high or low,
the [CHARGE] lamp blinks and the charging
time becomes longer than usual.
1
55GC-ENG.book 60 ページ ２００４年２月２５日 水曜日 午後２時２１分