52
VQT0T94
Quick guide (English)
ª
Power supply
Charging the battery
When this product is purchased, the battery is not
charged. Charge the battery before using this
product.
≥
If the DC input lead is connected to the AC
adaptor, then the battery will not get charged.
Remove the DC input lead from the AC adaptor.
1
Connect the AC mains lead to the AC
adaptor and the AC mains socket.
2
Put the battery on the battery mount by
aligning the mark, and then securely plug it
in.
Charging lamp
Lights up: Charging
Goes off: Charging completed
Flashing: The battery is over discharged
(discharged excessively). In a while,
the lamp will light up and normal
charging will start.
When the battery temperature is
excessively high or low, the
[CHARGE] lamp flashes and the
charging time will be longer than
normal.
Fitting the battery
Push the battery against the battery holder and
slide it until it clicks.
Removing the battery
While sliding the [BATT] lever, slide the battery
(or the DC input lead) to remove it.
≥
Hold the battery with your hand so it does not
fall.
ª
Inserting/removing a cassette
1
Slide the [OPEN/EJECT] lever and open the
cassette cover.
≥
When the cover is fully opened, the cassette
holder will come out.
2
After the cassette holder is opened, insert/
remove the cassette.
≥
When inserting a cassette, orient it as shown
in the figure, and then securely insert it as far
as it goes.
≥
When removing, pull it straight out.
3
Push the [PUSH] mark
1
in order to close
the cassette holder.
4
Only after the cassette holder is completely
housed, close the cassette cover.
BATT
OPEN/
EJECT
PUSH
1
VQT0T94SC.book 52 ページ ２００５年１１月２９日 火曜日 午後７時４５分
