en-20
Appendix
In these cases?
The power failed.
●
Keep the doors closed and do not store additional food.
●
[FRESH FREEZING] and [QUICK ICE MAKING] stop. Set these functions
again to use after power recovery.
The power plug was
disconnected.
●
Wait at least 7 minutes, and then plug in the power plug.
(If it is plugged in immediately, the compressor will be overloaded, which may
cause a malfunction.)
The refrigerator is not
used for a long time.
●
Remove all foods and drinks and clean the refrigerator.
Disconnect the power plug.
Clean the compartments and the ice-making tray. (P. 17 ~ P. 19)
Keep the doors opened for 2 to 3 days to dry the compartments.
(When drying is insufficient, the compartment may get moldy or have a foul
smell.)
The room lamp does not
turn on. The lamp cover
was broken.
●
When replace the room lamp, please contact with your dealer or service center.
Glass was broken.
(Glass trays
•
doors)
●
When glass trays and glass doors were broken, do not touch the broken glass
and contact with your dealer or service center immediately.
Moving the refrigerator
forward or backward.
Remove the leg cover, and then raise the adjustable legs. (P. 6)
Disconnect the power plug.
Move the refrigerator in the forward or backward direction.
(Using excessive force to move the refrigerator or moving it in other than a
forward or backward direction may damage the floor, so place a board or the like
on the floor.)
When you move or
transport the refrigerator.
●
Do not transport the refrigerator in a horizontal position.
(Doing so causes a failure of pipes around the compressor possible to be
broken.)
●
Remove the food and drinks in all compartments and discard the remaining
water and ice. Then, move the refrigerator with at least 2 people.
Remove the food and drinks and discard water in the water supply tank.
Stop the auto ice making function. (P. 15)
Clean the ice-making tray. (P. 19)
Remove the leg cover screw in the adjustable
legs. (P. 6) (Remove the leg cover before
transporting the refrigerator.)
Disconnect the power plug.
Place a vessel underneath the drainage hole.
Water may spill. Place a cloth, etc. below and in the
vicinity of the vessel.
Tilt the refrigerator backward to drain water from the
drainage hole. (To prevent water from leaking out,
tilt back the refrigerator slowly.)
When moving the refrigerator, place a protective
sheet, etc. on the passage because water may
remain in the evaporating dish.
Attention
●
If frost remains on the cooling unit (not visible from the outside) in the
refrigerator, then water may spill when it is moved.
(It takes approximately 15 hours for the frost on the cooling unit to melt after
the refrigerator power plug is disconnected.)
Drainage
hole
( Container whose height is
2 cm or less)
