6
Installation
Installation
Choosing the right location
1.Place the refrigerator in the following locations.
●
Locations free from heat and direct sunlight
Minimize reduction of cooling power, and prevent
electricity waste.
●
Well-ventilated locations with low humidity
Minimize rust and generation of condensation.
●
Sturdy and flat floors
With carpet, tatami mats, or vinyl floors,
deformation or discoloration may occur, so place a
board underneath the refrigerator.
●
Place the refrigerator away from other devices
Prevent noise and incorrect image display on TVs
and other devices.
●
Locations allowing the power plug to be cleaned
easily
Clean dust regularly.
(To prevent fire caused by dust.)
●
Locations that allow a heat to dissipate
The back surface may be fitted to the wall.
(Leave a space when vibration noise or discoloration
dirt of wall occurs.)
40 mm or more above the refrigerator
5 mm or more left and right
*
*
In case of installing by the wall.
(Figure as viewed from above.)
15 mm or more from the wall
If the clearance is less than 15 mm,
the door can not be opened at more
than 90 ° and glass trays, etc. may
not be removed.
■
Before using the refrigerator for the first time. (P. 17
~
P. 19)
•Wipe the inside of the refrigerator with a wet, soft cloth.
•Rinse the water supply tank, purification filter, and ice-making tray.
2. Fix the refrigerator.
Remove the leg cover.
Insert hands underneath the “ ” on both sides of
the leg cover and pull it out.
Leg cover
Turn the adjustable legs (right and left) until they
reach the floor to stabilize the refrigerator.
Adjustable legs
Reattach the leg cover.
●
If the refrigerator has not been stabilized completely, then you may hear knocking noises when the door is
opened/closed. (This will not affect the performance.)
Install the refrigerator on sturdy and flat floors.
■
If the door is slanted downwards.
Turn the adjustable leg on the lower side, as
shown in the diagram on the left, in order to adjust
the level.
•The freezer/refrigerator doors may tilt within four
to five days after installation due to the load of
the food or adaptation to the floor surface. In this
case turn the adjustable legs again to restore.
•If it does not help, then use an adjustment plates
(separately sold parts). (P. 27)
Lower the right
adjustable leg for
the right door.
Lower the left
adjustable leg for
the left door.
When the door is lowered.
■
Have any measures taken against tipping due to earthquakes?
In order to prevent the refrigerator from tipping, permanently fix it by
using belts, etc.