Panasonic NNS252BF - MICROWAVE OVEN/OTR, Руководство по обслуживанию

Страница: 16 / 36

9.5. Door assembly
1. Remove door C from door E by carefully pulling outward
starting from upper right hand corner using a flat blade
screwdriver.
2. Separate door E from tabs on door A and remove door A.
3. Remove door screen B from door A.
4. Remove door key and door key spring.
5. Open Door E at the opening angle of approximately
10° (Note: The door cannot be removed if the opening
angle is greater than 10°) .
6. Remove the door E from its hinges by pushing the door E´s
bottom upward and out.
7. Replace other components.
NOTE:
Door alignment is critical. If door is misaligned, apply
pressure until alignment is achieved.
NOTE:
After replacement of the defective component parts of
the door, reassemble, install, and perform microwave
leakage test.
9.6. Stirrer motor
1. Release 1 canoe clip on the cover and then remove the
cover.
2. Pull out stirrer.
3. Remove 3 screws which holding exhaust guide A on the
oven.
4. Tilt exhaust guide A.
5. Disconnect 2 connectors from stirrer motor.
6. Remove 1 screw holding stirrer motor.
7. Release from retainer tab by turn spinning certain angle,
remove stirrer motor.
9.7. Blower motor (U)
1. Disconnect 1 connector from blower motor (U).
2. Remove 2 screws which holding blower motor (U) on the
oven.
3. Remove blower motor (U).
9.8. Fan motor A (for H.V. inverter
(U) cooling)
Disassembly procedure step 1~8 same as above H.V. Inverter
(U).
9. Pull out fan blade.
10. Remove 2 screws which holding fan motor A on the orifice,
and remove fan motor A.
16
NN-S262SF / NN-S262BF / NN-S262WF / NN-S252BF / NN-S252WF