Panasonic NN-T221MB, Руководство по обслуживанию, Страница: 13 / 21

13
Figure 6
8.6. Temp Sensor (Thermal Protec-
tor)
1. Replace the temperature sensor by replacing the lead-
wire harness B as a complete item.
2. Disconnect screw holding temperature sensor to the
chassis
3. Disconnect connector CN4 from DPC DU.
4. Disconnect terminal from SW4 (secondary latch switch)
5. Replace as a whole item.
8.7. Door disassembly
1. Remove door C from door E by carefully pulling outward
starting from the upper right hand corner using a flat
blade screwdriver.
2. Remove four screws holding the door E to the door A
assembly.
3. Remove the door screen B by carefully un-clipping the
screen from the door A catch hooks. Care must be taken
not to damage these hooks during disassembly.
4. Remove the door key and spring from the door E.
After replacement of the defective component parts of the
door, reassemble and follow the instructions below for
proper installation and adjustment so as to prevent exces-
sive microwave leakage.
1. When mounting the door to the oven, be sure to adjust
the door parallel to the bottom line of the oven face plate
by moving the upper hinge in the direction necessary for
proper alignment.
2. Adjust so that the door has no play between the inner
door surface and the oven front surface. If the door
assembly is not mounted properly, microwave power may
leak from the clearance between the door and oven.
3. Perform the microwave leakage test.
Disassembly of the door.
Figure 7
Adjusting the door hinge.
Figure 8