Panasonic NN-GD356W, Руководство по обслуживанию

Страница: 10 / 31

To replace pop-up dial
Remove pop-up dial from small D.P.C. board (DU) by
pulling it straight out.
6. Release 2 locking tabs on escutcheon base to remove big
D.P.C. board (DU)
7. Remove 4 screws holding D.P.C. board (AU) on
escutcheon base.
8. Release 6 locking tabs on escutcheon base to remove
D.P.C. board (AU).
To replace membrane key board
Use such as knife etc. tools poke from the edge of
escutcheon sheet and peel off escutcheon sheet and
membrane key board completely from escutcheon base.
NOTE:
1. The membrane key board is attached to the
escutcheon base with double faced adhesive tape.
Therefore, applying hot air such as using a hair dryer is
recommended for smoother removal.
2. When installing new membrane key board, make
sure that the surface of escutcheon base is cleaned
sufficiently so that any problems (shorted contacts or
uneven surface) can be avoided.
3. Alignment position of membrane key board is as
follows;
Membrane key board: Right and upper edges
Escutcheon sheet: Right and upper edges
4.3. Low voltage transformer
and/or power relays (RY1,
RY2)
NOTE:
Be sure to ground any static electric charge built up on
your body before handling the DPC.
1. Using solder wick or a desoldering tool and 30W soldering
iron carefully remove all solder from the terminal pins of the
low voltage transformer and/or power relays.
NOTE:
Do not use a soldering iron or desoldering tool of
more than 30 watts on D.P.C. contacts.
2. With all the terminal pins cleaned and separated from
D.P.C. contacts, remove the defective transformer/power
relays, Replace components making sure all terminal pins
are inserted completely resolder all terminal contacts
carefully.
4.4. Fan motor
1. Disconnect 2 lead wires from fan motor terminals.
2. Remove 3 screws holding orifice assy and detach the orifice
assy from oven assy.
3. Remove fan blade from the motor shart by pulling it stralght
out.
4. Remove 2 screws holding fan motor on orifice assy and
detach the fan motor from orifice assy.
10
NN-GD376S / NN-GD366M / NN-GD356W