Panasonic NE1064T - COMMERCIAL MICROWAVE, Руководство по эксплуатации

Страница: 17 / 20

Dis^ni^cs Failure Code Esqsiafialiiif«
This oven monitors its operation and displays a Failure Code in the display window when a problem occurs.
What to do when a failure code appears:
CODE CAUSE WHAT TO DO
F01 ’Overcooked food
’Temperature of exhaust air too high. ’Press
STOP/RESET
Pad to stop beep.
’Unplug oven and wait at least 30 minutes
before reconnecting.
’Wait for oven to cool down and reset.
’If a flame is present, do not open oven door.
’If normal operation does not resume, call the
service agent with information of failure code.
F33-34
’Defective sensor circuit ’ Unplug the oven and wait more than 10
seconds before reconnecting.
’ If normal operation does not resume, call the
service agent with the information of failure
code.
F44
’When a pad was pressed for more
than 30 seconds
’Defective pad or control circuit
NOTE:
Above codes shown in display do not indicate all the possible failures on the unit.
Care of Your Microwave Oven
1. Unplug the oven before cleaning.
2. Keep the inside of the oven clean. When food
spatters or spilled liquids adhere to oven walls, wipe
with a damp paper towel. Mild detergent may tie
used if the oven gets very dirty. The use of harsh
detergent or abrasives is not recommended. The air
intake splash guard/lighl diffuser can be removed
for cleaning by removing the center plugs from the
two plastic rivets. The top is held by two tabs.
Wash in warm dishwater and replace.
3. The outside oven surfaces should be cleaned with
a damp paper towel. To prevent damage to the
operating parts inside the oven, water should not
be allowed to seep into the ventilation openings.
4. If the Control Panel becomes wet, clean with a soft,
dry cloth. Do not use harsh detergents or abrasives
on Control Panel. When cleaning the Control
Panel, leave oven door open to prevent oven from
accidentally turning on. After cleaning, touch
STOP/RESET
Pad to clear display window.
5. If steam accumulates inside or around the outside
of the oven door, wipe with a soft paper towel. This
may occur when the microwave oven is operated
under high humidity conditions and in no way
indicates malfunction of the unit.
6. Clean off the grease and dust on bottom surfaces
often. Use warm detergent solution,
7. Cleaning inside the oven outer panel and inside the
oven base should be performed only by qualified
service personnel after taking precautions to drain
all stored voltage potential. The bottom is
accessible by removing the center section of the
base and the power and sensor control areas are
within the outer wrap around housing. Avoid using
liquids and cleaning solutions in these areas. Use a
dry soft bristle brush or a cloth. Replace all parts—
Do not connect the oven to the electricity supply if
any parts are not reassembled.
1 7