Panasonic NA-F75G6, Руководство по обслуживанию

Страница: 12 / 32

NA-F62G6 / F65G6 / F70G6 / F75G6 / F75S6 / F70S6
12
7 Troubleshooting Guide
7.1. Test Running without water
< Method to test running without water >
1. Set the power switch to [OFF].
2. Press and hold both the [Process] and [Power Soak] buttons with one hand.
3. Press the power ON button.
4. Release the your fingers from the buttons and power switch which you pressed in steps 2. and 3. above.
(Check A can be carried out in this state with your fingers released.)
5. Within three seconds, press the [Process] button to set to the desired check procedure as follows.
Number of times
the [Process]
button is pressed
Check
Procedures
Check contents Lamp illumination condition Operation condition
• End signal
• Auto power-off • The end buzzer sounds three times
after operation is finished.
• The lamps as shown in figure will simul-
taneously flash on and off and the
power will automatically be switched off.
• Abnormal in memory storage.
It should be indicated [02].
• In case of the end buzzer is [switched
off],[Child Lock] will be switched on.
• Abnormal signal of
memory:
[H05] will be displayed.
• Indication of [H17] is
given for thermister
error.
• Even if there is no water in the tub, the
washing operation will continue for six
minutes.
• Press the [Program] button to change
the current.
Every 1 second, wash current will be
changed.
[Normal] - [Gentle Hand Wash]
Normal current : LED display [1] for 5
seconds.
Gentle Hand Wash current : LED dis-
play [5] for 5 seconds.
• Pressing [Power Soak] is able to switch
over program(agitation

water supply

hot water supply).
• Spin operation check.
• Abnormal signal of lid
switch and SF switch.
• The spinning operation will continue for
six minutes.
• SF SW 2 OFF(Open the lid) [hours]
lamp On.
• SF SW 1 OFF(Open the lid) [Reserve]
lamp On.
• SF SW 1 and 2 are both OFF. Buzzer
notifying that the lid is open while the
tub is rotating.