
20
Hose Hole Cover A
Bottom Cover
Base
Convex Part
A. Purpose
For safety precaution.
B. How to install Bottom Cover to the Base
Cover (about 1/3 from the bottom) and slightly
bend the upper part toward you so that the
convex part on both sides don’t touch the back
of the body. Then slide it down completely.
4. Securely fasten the 2 screws of the Bottom
Cover to the Base.
1. Lay down the washing machine with the back
body facing to the upside.
2. Adjust the Hose Hole Cover A (accessory) to the
slot at the base.
3. Fix Bottom Cover (accessory) where surface with
UP indication is facing to the washing machine.
And slide down the bottom tip of the Bottom
Bottom Cover Installation Instruction
Drain Hose Installation Instruction
(The drain hose is installed inside the bottom of the base.)
1. Lay down the washing machine with the back
body facing to the upside.
Drain Hose
Rear
Tape
To change the drain hose to opposite.
(Ex. Changing hose position from right to left.)
1. Lay down the washing machine with the back
body facing to the upside.
2. Remove the screw fixing the hose holder.
3. Remove the hose holder from the base.
Screw
Hose Holder
4. Move the hose holder to opposite side.
Then insert the hose holder to left hose outlet
position of the base.
Front
Caution
Make sure the hose holder is fixed on the base properly
to avoid water leaking caused of the hose damaged.
Note
Make sure to remount the bottom cover after pulling out
the drain hose or changing its position.
Note
Do not remove the hose
holder from the drain hose.
Spread a mat such as cardboard under the body to avoid scratches.
Base
Drain Hose
Pull out.
2. Peel off the tape and pull out the drain hose
from the base.
5. Fix the hose holder with screw properly.
Note
Make sure the drain hose
is not twisted.
NA-F70HR2_EN.indd 20
2/28/12 1:26:52 PM