28 - Maintenance
Maintenance
Cleaning the water-supply
filter
Clean the filter if water is not supplied
properly.
Turn the tap off.
1.
Switch on the appliance.
2.
Select the Cotton programme, and
3.
then press the Start button.
After 1 minute, switch off the
4.
appliance. Water has drained out of
the water-supply hose.
Disconnect the water-supply hose
5.
from the appliance.
Clean the filter, which is on the rear
6.
of the appliance.
Use a small brush, for example, a
toothbrush.
If the unit is supplied with the hose
7.
fitted with a water-supply hose, turn
off the tap supplying the appliance,
disconnect the hose from the tap,
and then clean the filter on hose in
the same way.
Reconnect the water-supply hose.
8.
Tighten the plastic joint firmly.
Turn on the tap, then check for leaks.
9.
Preventing a frozen
water-supply hose
If the appliance is delivered in freezing
weather conditions, after setting up, leave
it at room temperature for 24 hours before
using. This will ensure that the
water-supply hose does not get clogged up
with ice.
If your water-supply hose freezes, perform
the following procedures:
Wrap warm towels around the joints
1.
of the water-supply hose.
Add 2 to 3 litres of warm water to the
2.
drum.
Start the wash with the Drain only
3.
function of the Mode function, using
the Option button. (See pages 21 and
23.)
Joints Tap
Water-supply hose
about
50°C
NA-168VX3_Australia.indb 28
2011-9-5 16:17:11
