Maintenance - 29
Maintenance
Cleaning the water supply
filter
Clean the filter if water is not supplied
properly.
1. Turn the tap off.
2. Switch on the appliance.
3. Select the Cotton programme, and
then press the Start button. Drainage
begins when the appliance is started.
4. After 2 minutes, switch off the
appliance. Water has drained out of
the water supply hose
.
5. Disconnect the water supply hose
from the appliance.
6. Clean the filter, which is on the rear
of the appliance.
Use a small brush, for example,
a toothbrush.
7. Reconnect the water supply hose.
Tighten the plastic joint firmly.
8. Turn on the tap and then check for
leaks.
3. Put your finger on the tab near the
front of the softener cover and pull
it up to remove it from the detergent
drawer.
4. Wash out the detergent residue with
water.
Use a cloth to wipe the water from the
appliance.
5. Replace the softener cover.
6. Reinsert the detergent drawer while
pressing down on the tab as shown
in the figure below.
Tab
NA-147VR1_HK_English_Main.indd 19
2019/06/04 13:53