EN7
English
Containers and other parts
Mill Blade
Motor housing
Wash the parts using a soft sponge soaked in
diluted kitchen detergent (neutral). Carefully clean
blades with a brush. Rinse and dry thoroughly.
■
●
Remove the gaskets before washing.
Carefully clean blades with a brush. Do
not use water.
(
Brush is not provided.
)
Wipe motor housing with a damp cloth.
In case of overload and overheating, the protection device is triggered to stop operation and it is not abnormal.
After rotation stops, follow the below steps:
■
●
Do not use the appliance repeatly without any countermeasure.
1
Turn the rotary switch to "0" position, unplug the appliance.
2
Remove blender jug or mill container from motor housing.
Reduce the ingredients to less than half. (For blender jug, it also can add liquid.)
■
● Remove the prohibted ingredient if used.
3
Reset the blender jug or mill container, start blending again.
(P. EN6)
If the appliance still does not operate after performing the above, overheating protection has been activated.
Turn the rotary switch to "0" position, unplug and rest the appliance for about 15 minutes or more (until motor housing returns to a
normal temperature) to release overheating protection before using again.
(If appliance still does not operate, contact Service Centre for inspection or repair.)
Safety lock pin
Safety pin
1500
1000
500
Cleaning and Care
Safety Lock
Overload and Overheating Protection
Add 400 mL clean water into the blender jug, plug in and blend for
about 1 minute.
■
● Unplug before cleaning.
■
● Clean the parts thoroughly after every use. Keep all parts clean and dry always.
■
●
Do not wash any part of the appliance in the dishwasher.
■
● Do not use benzine, thinner, bleach, alcohol, nylon face of sponge, metal brushes or polish powder etc.
■
● Some discoloration of the plastic parts may occur upon usage but it does not affect usage.
Blender jug prewash
■
● Assemble the blender jug base/mill container base with the
blender jug/mill container.
■
● Dry the lid thoroughly, then keep it separately.
Storing
The safety lock has been designed to prevent the blender
from switching on when blender jug or mill container is not
properly in place.
When the safety pin on back of the blender jug base is
pushed during assembling, motor does not operate.
