instructed in the respective removal sections.
3. Turn the vacuum over to the front side.
4. Remove the four (4) screws from the motor case and then
remove the motor case.
5. Disconnect the motor leads and remove the motor. Remove
the motor support rubber (rear), noise suppressor, cooling
guide, motor flange, and the motor support rubber (front).
Place these items on the new motor.
3.8.2. Installation
1. Place the motor back into the dust compartment with
brushes aligned parallel to the front edge of the dust
compartment.
2. Rewire per the Pictorial Diagram.
3. Replace the motor case and the four (4) screws.
4. Turn the vacuum back over and replace the plastic shaft,
light bulb assembly, nozzle housing, belt, agitator
assembly, and lower plate according to the respective
installation instructions.
14
MC-UG589-00
