3.6.2. Installation
1. Replace damaged lead. carefully routing mains lead as
illustrated.
2. Reinstall handle as outlined in the handle installation
section.
3. Replace the cord stopper, the two (2) cord stopper screws
and the wire connectors.
NOTE: Never reuse a cord stopper. Always install a new
cord stopper whenever the old one is removed.
NOTE: For general servicing, it is necessary to eliminate
pinching of any wire during reassembly. After servicing
any electrical component or electrical enclosure, the unit
should be reassembled and checked for dielectric
breakdown or current leakage.
3.7. ON/OFF Switch Replacement
3.7.1. Removal
1. Remove the dust cover to expose the electrical connections
of the ON/OFF switch.
2. Remove wires from switch.
3. Remove the ON/OFF switch, (for ON/OFF switch
replacement) by depressing the switch retaining tabs while
pushing up out of the dust compartment at the same time.
3.7.2. Installation
1. Re-connect lead wires to ON/OFF switch.
3.8. Motor Protector Replacement
3.8.1. Removal
1. Remove the dust cover.
2. Remove the motor protector cover, by releasing one of the
tabs that secure it to the dust compartment. Take care not
to break the tabs during removal.
3.8.2. Installation
1. Reinstall the motor protector and protector spring into the
dust compartment. Replace the motor protector cover by
applying pressure until both tabs snap into place.
NOTE: For general servicing, it is necessary to eliminate
pinching of any wire during reassembly. After servicing
any electrical component or electrical enclosure, the unit
should be reassembled and checked for dielectric
breakdown or current leakage.
13
MC-E4061-00
