Panasonic LP-M Series, Руководство по обслуживанию

Страница: 107 / 174

107
3-5-11 Safety function input (laser stop 1)
T3
T4
T2
T1
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
[Input]
[Output]
READY OUT
MARKING OUT
MARK END OUT
LASER OUT
LASER IN
TRIG. IN
ALARM RES. IN
SHUTTER
OUT *2
Marking interrupted
(Open)
(Open)
(Close)
(Close)
ALARM OUT
(Active Low)
WARNING OUT
(Active Low)
SHUTTER B IN
LASER STOP
1 IN *1
SHUTTER A IN
*1 : For LP-Mxxx-LS1 type, control the laser stop with dual input of LASER STOP 1A and LASER STOP 1B.
*2 : Shutter output signal has around 200ms to max. 1 sec. delay from each input signal for the shutter open / close
operation time.
The operation behavior of Shutter 2 output on LP-Mxxx/Mxxx-LS1 type is the same as Shutter output.
Item Time Remarks
T1 2 to 510 ms Even when the marking is interrupted due to the laser stop input, the mark end outputs.
This signal is a one-shot output. Set the output time on the environment setting screen.
There is a margin for the setting value.
T2 100 ms or more Keep the ON status for 100 ms or more.
T3 ― Time for data creation or time for laser pumping, whichever is longer.
T4 approx. 20 sec. The time from turning ON the laser pumping input to completion of pumping.
ンㄆㄇㄆㄓㄆㄏ㄄ㄆ
• If LASER STOP INPUT 1 is released when laser is not radiating, the shutter is closed keeping the laser pumping on.
(Warning status)
• If LASER STOP INPUT 1 is released when laser is radiating, the laser pumping is turned off, and the shutter is closed.
(Alarm status)
• For release method of alarm and warning, refer to “Release method of alarm” (P.161) and “Release method of warning”
(P.164), respectively.
ME-LPM-SSM-10