Panasonic LP-400 Series, Руководство по внешнему управлению

Страница: 117 / 180

117
⿎ Processing condition : LAY
Sets X/Y coordinate offset and laser power correction ratio, etc. for the specified processing condition No.
• Setting / Readout data of processing condition
STX LAY
Sub
command
[Processing condition No.] [Area No.] [X offset]
[Y offset] [Rotation angle] [Laser power correction]
[Scan speed correction]
[Laser pulse cycle correction]
Max. 34-byte (LP-V series),
Max. 31-byte (LP-400/LP-W series)
(Check
sum)
Delimiter
Sub command is “S” at the time of setting and “A” for response data at the time of readout.
• Readout request of processing condition
STX LAY R
[Processing condition No.]
1-byte
(Check
sum)
Delimiter
Name
Data length
[byte]
Description Remarks
Processing
condition No.
1 “0”–“7”
Area No. 1 “0”–“9”, “A”–“F”
Specifies which area part is the
marking position of the concatenated
marking on the flying object.
In case of marking static object,
specify “0”.
X offset 8
Model type* Setting range [mm]
LP-V10 “-045.000”–“+045.000”
LP-4x0 “-055.000”–“+055.000”
LP-4x5/LP-V15 “-080.000”–“+080.000”
LP-4x1/LP-W “-027.500”–“+027.500”
Y offset 8
Rotation angle 7 “-180.00”–“+180.00” [°]
Laser power
correction
3 “000”–“200” [%]
• The correction ratio is calculated
using the value set at the laser
setting as 100%.
• With LP-400/LP-W series, nothing
should be input in Laser Pulse
Cycle Correction.
Scan speed
correction
3 “005”–“500” [%]
(Laser pulse cycle
correction)
(Only for LP-V
series)
(3) “050”–“200” [%]
* For the detail of the model type, refer to “Target laser marker” (P.8).
ME-LP400V-EX-6