Panasonic LP-400 Series, Руководство по внешнему управлению

Страница: 114 / 180

114
⿎ Processing element : FIG
Sets the processing element type (straight line, circle, arc) and coordinates.
• Setting / Readout data of processing element
STX FIG
Sub
command
[Processing condition No.] [Processing element No.]
[Element type] [depending on the element type]
Max. 60-byte
(Check
sum)
Delimiter
Sub command is “S” at the time of setting and “A” for response data at the time of readout.
• Readout request of processing element
STX FIG R
[Processing condition No.] [Processing element No.]
4-byte
(Check
sum)
Delimiter
1. For straight line: (Data length: Max. 51-byte)
Name
Data length
[byte]
Description Remarks
Processing
condition No.
1 “0”–“7”
Processing
element No.
3 “000”–“031”
Element type 1 “0”: straight line
X coordinate of
start point
8
Model type* Setting range [mm]
LP-V10 “-045.000”–“+045.000”
LP-4x0 “-055.000”–“+055.000”
LP-4x5/LP-V15 “-080.000”–“+080.000”
LP-4x1/LP-W “-027.500”–“+027.500”
Y coordinate of
start point
8
X coordinate of
end point
8
Y coordinate of
end point
8
Dashed line:
Length of solid
part
(7)
Model type* Setting range [mm]
LP-V10 “000.010”–“090.000”
LP-4x0 “000.010”–“110.000”
LP-4x5/LP-V15 “000.010”–“160.000”
LP-4x1/LP-W “000.010”–“055.000”
Set the larger value than “Line width” in
laser setting screen.
To make it not dashed line (solid line),
input nothing.
Dashed line:
Length of blank
part
(7)
Model type* Setting range [mm]
LP-V10 “000.000”–“090.000”
LP-4x0 “000.000”–“110.000”
LP-4x5/LP-V15 “000.000”–“160.000”
LP-4x1/LP-W “000.000”–“055.000”
To make it not dashed line (solid line),
input nothing.
For deletion of the processing element, set the element type to straight line, and set X and Y coordinates of both start and
end points to “0”.
* For the detail of the model type, refer to “Target laser marker” (P.8).
ME-LP400V-EX-6