Remote access code
A 3-digit remote access code must be entered
when operating the answering system remotely.
This code prevents unauthorized parties from
listening to your messages remotely. The default
setting is
“
000
”
.
Important:
R
To prevent unauthorized access to this product,
we recommend that you regularly change the
remote code.
1
M
Menu
N
2
MbN
:
“
Answering System
”
a
M
Select
N
3
MbN
:
“
Remote Password
”
a
M
Select
N
4
MbN
:
“
Set Passcode
”
a
M
Select
N
5
Enter the desired 3-digit remote access
code.
a
M
Save
N
6
Press
M
Back
N
or
M
Home
N
repeatedly to
return to standby mode.
Using the answering system remotely
1
Dial your landline phone number from a
touch-tone phone.
2
After the greeting message starts, enter your
remote access code.
3
Follow the voice guidance prompts as
necessary or control the unit using remote
commands (page 28).
4
When finished, hang up.
Voice guidance
To start the voice guidance, press
7
. The voice
guidance announces the available remote
commands (page 28).
Note:
R
If you do not press any dial keys within 10
seconds after a voice guidance prompt, the unit
disconnects your call.
Remote commands
You can press dial keys to access certain
answering system functions without waiting for the
voice guidance to prompt you.
Key
Operation
1
Repeat message (during playback)
2
Play messages
Stop playback
3
Skip message (during playback)
7
Start voice guidance
4
Turn answering system on or off
6
Play greeting
0
Erase currently playing message
*1 If pressed within the first 5 seconds of a
message, the previous message is played.
Answering system settings
Call screening
While a caller is leaving a message, you can listen
to the call through the unit’s speaker.
To adjust the speaker volume, press
MjN
or
MkN
repeatedly.
You can answer the call by lifting the corded
handset from the base unit.
The default setting is
“
On
”
.
1
M
Menu
N
2
MbN
:
“
Answering System
”
a
M
Select
N
3
MbN
:
“
Call Screening
”
a
M
Select
N
4
MbN
: Select the desired setting.
a
M
Select
N
5
Press
M
Back
N
or
M
Home
N
repeatedly to return
to standby mode.
Number of rings before the unit
answers a call
You can change the number of times the phone
rings
“
Answer Delay
”
before the unit answers
calls. You can select 2 to 7 rings, or
“
Toll
Saver
”
.
The default setting is
“
2 Rings
”
.
“
Toll Saver
”
: The unit’s answering system
answers at the end of the 3nd ring when new
messages have been recorded, or at the end of
the 5th ring when there are no new messages. If
you call your phone from outside to listen to new
messages (page 27), you know that there are no
new messages when the phone rings for the 4rd
28
For assistance, please visit http://shop.panasonic.com/support
Answering System
TGW420_(en)_OI_1226_ver06.pdf 28
2019/12/26 13:15:32
