Problem
Cause/solution
The unit does not emit the
specified number of rings.
R
If the ring once setting is turned off (page 33), the number
of rings decreases by 1 from the specified number of
rings.
Bluetooth PIN
Problem
Cause/solution
I cannot remember the PIN.
R
Change the PIN using the following method.
Handset:
1
M
MENU
N#619
2
*7000
3
Enter the new 4-digit PIN.
a
M
OK
N
4
Enter the new 4-digit PIN again.
a
M
SAVE
N
a
M
OFF
N
Voicemail
Problem
Cause/solution
“
Voicemail msg. via
phone co.
”
is shown on the
handset display.
or
“
Voicemail msg.
”
is shown
on the base unit display.
How do I remove this message
from the display?
R
This notification is displayed when your phone service
provider’s voicemail service (not the unit’s answering
system) has recorded a message for you. Typically you
can remove this notification from the display by listening
to the message. To listen to the message, dial the
voicemail number provided by your phone service
provider (for most cases, this will be your own phone
number), and follow the voice instructions. Depending on
your phone service provider, you may need to remove all
messages from your voice mailbox to remove the
notification. You can also remove this notification by
pressing and holding
#
until the unit beeps.
Liquid damage
Problem
Cause/solution
Liquid or other form of moisture
has entered the handset/base
unit.
R
Disconnect the AC adaptor and telephone line cord from
the base unit. Remove the batteries from the handset and
leave to dry for at least 3 days. After the handset/base
unit are completely dry, reconnect the AC adaptor and
telephone line cord. Insert the batteries and charge fully
before use. If the unit does not work properly, contact an
authorized service centre.
Caution:
R
To avoid permanent damage, do not use a microwave oven to speed up the drying process.
80
For assistance, visit www.panasonic.ca/english/support
Useful Information
TG175CSK(en)_0324_ver011.pdf 80
2016/03/24 9:06:22
