Panasonic KX-TGE432, Руководство по эксплуатации

Страница: 35 / 72

2
MbN : Select the desired setting. a
M SAVE N
R If you select “
Off
” , press M OFF N to
exit.
3
Enter the desired hour and minute you
wish to start this feature.
4
* : Select “
AM
” or “
PM
” . a M OK N
5
Enter the desired hour and minute you
wish to end this feature.
6
* : Select “
AM
” or “
PM
” .
7
M SAVE N a M OFF N
*1 KX-TGE440 series: page 3
Changing the start and end time
1
For handset setting: M MENU N#237
For base unit setting (using a
handset)
*1
: M MENU N#*237
2
Continue from step 3, “Turning silent
mode on/off”, page 34.
*1 KX-TGE440 series: page 3
Selecting groups to bypass silent
mode
1
For handset setting: M MENU N#241
For base unit setting (using a
handset)
*1
: M MENU N#*241
2
MbN : Select the desired groups. a
M SELECT N
R “ ” is displayed next to the selected
group numbers.
R To cancel the selected group:
MbN : Select the group. a Press
M SELECT N again. “ ” disappears.
3
M SAVE N a M OFF N
*1 KX-TGE440 series: page 3
Baby monitor
This feature allows you to listen in on a room
where another handset is located, allowing
you to easily monitor from different areas of
the house or even while away from home. The
monitored handset (placed in a baby’s room,
for example) will automatically call the
monitoring handset, base unit, or the phone
number stored when it detects sound.
Important:
R Before using this feature, we recommend
that you test this feature and adjust the
baby monitor sensitivity as needed,
especially if you plan to monitor from
outside.
R This feature should not be used as a
substitute for a medical or caregiver’s
supervision. It is the caregiver’s
responsibility to stay close enough to
handle any eventuality.
Note:
R If the unit is connected to a PBX system,
you cannot set the baby monitor.
R During the monitoring mode, battery
consumption is faster than usual. We
recommend leaving the monitored handset
on the base unit or charger.
R The monitored handset never rings while it
is being monitored. If the base unit is
placed near the monitored handset, we
recommend turning off the base unit ringer
volume (page 17).
Setting the baby monitor
Perform the setting operation with the handset
to be monitored (for example, the handset
placed in a baby’s room).
To monitor with a unit
The internal baby monitor feature is available:
– between handsets
– between a handset and the base unit
*1
*1 KX-TGE440 series: page 3
1
M MENU N#268
2
MbN : “
On
” a M SELECT N
3
MbN : Select the desired unit’s number to
monitor with. a M SAVE N
R “
Baby monitor
” will be displayed.
R The registered unit’s name/number is
displayed.
For assistance, please visit http://shop.panasonic.com/support 35
Programming
TGE43xUS(en)_1112_ver021.pdf 35 2015/11/12 10:12:57