Panasonic KX-TGE432, Руководство по эксплуатации

Страница: 21 / 72

2
MbN : Select the desired unit or “
Voice
paging
” . a M SELECT N
R If you select “
Voice paging
” , speak
into the microphone after the beep.
Your voice will be heard using the
speakers of the base unit
*1 and all
handsets, until a paged party answers
your page or until you press
M OFF N .
After the other party answers, the
speakerphone mode is turned on.
3
When you finish talking, press M OFF N .
*1 KX-TGE440 series: page 3
Note:
R You can also use the M INTERCOM N soft
key, if displayed, to make intercom calls.
R You cannot use voice paging if other units
are in use.
R Voice paging is not available when a range
extender (KX-TGA405) is registered to the
base unit.
Base unit *1
*1 KX-TGE440 series: page 3
1
Press M INTERCOM N .
When 2 or more handsets are
registered:
– To page a specific handset, enter the
handset number.
– To page all handsets, press 0 or wait
for a few seconds.
2
When you finish talking, press MZN .
Answering an intercom call
Handset
1
Press M N to answer the page.
2
When you finish talking, press M OFF N .
Base unit
*1
*1 KX-TGE440 series: page 3
1
Press MZN to answer the page.
2
When you finish talking, press MZN .
Turning auto intercom on/off
This feature allows the handset or base unit to
answer intercom calls automatically when it is
called. You do not need to press
M N or
MZN . When this feature is set to “
On
” , the
monitoring handset or base unit for the baby
monitor feature (page 37) will also answer
baby monitor calls automatically. The default
setting is
“ Off ” .
1
For handset setting: M MENU N#273
For base unit setting (using a
handset)
*1 : M MENU N#*273
2
MbN : Select the desired setting. a
M SAVE N a M OFF N
*1 KX-TGE440 series: page 3
Note:
R This feature is not available for all handsets
paging and voice paging even if it is turned
on.
Power backup operation
When a power failure occurs, the charged
handset temporarily supplies power to the
base unit (power backup mode). This allows
you to make and receive calls using a handset
during a power failure. The base unit will not
perform any other functions. However, some
functions such as Caller ID and phonebook
are available only when using a handset other
than the handset supplying power to the base
unit. You can program
“ Power failure ”
and the default setting is “
Auto
” (page 32).
Important:
R If a handset is not placed on the base unit
when a power failure occurs,
“
Base no
power Press OFF
” is displayed. After
pressing M OFF N on the handset, place it on
the base unit to start power backup mode.
R Power backup mode will not work if the
battery level of the power supplying
handset is or .
R Do not lift the power supplying handset
from the base unit during power backup
mode.
For assistance, please visit http://shop.panasonic.com/support 21
Making/Answering Calls
TGE43xUS(en)_1112_ver021.pdf 21 2015/11/12 10:12:56