6
Registering the handset to the base unit
Ensure that the handset is switched on. If it is not on, press and hold
{ih}
for
few seconds to turn the handset on.
1
Handset:
Lift the handset and press
{ih}
.
2
Base unit:
Proceed with the operation for your model.
N
KX-TG8411
Press and hold
{x}
for about 5 seconds. (No registration tone)
N
KX-TG8421
Press and hold
{x}
for about 5 seconds, until the registration tone sounds.
• If all registered handsets start ringing, press the same button to stop. Then
repeat this step.
3
Handset:
Place the handset on the base unit.
• Continue the operation even when the handset display shows
“
Please wait for 1 minute.
”
.
4
With the handset still on the base unit, wait until a confirmation tone sounds
and
w
stops flashing.
Note:
• If an error tone sounds, or if
w
is still flashing, register the handset according
to the base unit’s operating instructions.
• The KX-TG8411 does not feature an answering system.
• Answering system features are available only when this handset is registered
to the KX-TG8421.
For your safety
To prevent severe injury and loss of life/property, read this section carefully before using the
product to ensure proper and safe operation of your product.
WARNING
Power connection
• Completely insert the AC adaptor/power plug into the power outlet. Failure to do so may
cause electric shock and/or excessive heat resulting in a fire.
• Regularly remove any dust, etc. from the AC adaptor/power plug by pulling it from the
power outlet, then wiping with a dry cloth. Accumulated dust may cause an insulation
defect from moisture, etc. resulting in a fire.
• Unplug the product from power outlets if it emits smoke, an abnormal smell, or makes an
unusual noise. These conditions can cause fire or electric shock. Confirm that smoke has
stopped emitting and contact an authorised service centre.
TGA840FX(fx).book Page 6 Tuesday, March 3, 2009 5:07 PM
