Programming
29
busy tone to the caller, and then
disconnects the call.
Important:
L
When the unit receives a call from a
number that is stored in the call barred
list, the call is logged in the caller list
(page 33) with
7
after the call is
disconnected.
Storing unwanted callers
You can store up to 30 phone numbers in
the call barred list by using the caller list
or by entering the numbers directly.
Important:
L
You must store the phone number
with an area code in the call barred
list.
■
From the caller list:
1
{
<
}
(
y
)
2
{V}
/
{^}
: Select the entry to be
barred.
i
M
i
I
3
{V}
/
{^}
:
“
Caller Barred
”
i
M
4
{V}
/
{^}
:
“
Yes
”
i
M
i
{i
c
}
■
By entering phone numbers:
1
1
i
{
#
}{
2
}{
1
}{
7
}
i
m
2
Enter the phone number (24
digits max.).
i
M
L
To erase a digit, press
^
.
3
{i
c
}
Viewing/editing/erasing bar call
numbers
1
1
i
{
#
}{
2
}{
1
}{
7
}
2
{V}
/
{^}
: Select the desired entry.
L
To exit, press
{i
c
}
.
3
To edit a number:
~
i
Edit the phone number.
i
M
i
{i
c
}
To erase a number:
W
i
{V}
/
{^}
:
“
Yes
”
i
M
i
{i
c
}
Note:
L
When editing, press the desired dial
key to add,
^
to erase.
Changing the base unit PIN
(Personal Identification
Number)
Important:
L
If you change the PIN, please make
note of your new PIN. The unit will not
reveal the PIN to you. If you forget
your PIN, contact an authorised
service centre.
1
1
i
{
#
}{
1
}{
3
}{
2
}
2
Enter the current 4-digit base unit
PIN (default:
“
0000
”
).
3
Enter the new 4-digit base unit PIN.
i
M
i
{i
c
}
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to a
single base unit.
Important:
L
The additional handset model
recommended for use with this unit is
noted on page 4. If another handset
model is used, certain operations
(handset settings, base unit settings,
etc.) may not be available.
Additional base units
Handsets can be registered to up to 4
base units, allowing you to add
additional base units and extend the
area in which your handset(s) can be
TG7522_7523AL(e).book Page 29 Monday, February 8, 2010 1:29 PM
