Useful Information
36
Telephone
Problem
Cause & solution
w
is flashing.
L
The handset is not registered to the base unit.
Register it (page 29).
L
The handset is too far from the base unit. Move
closer.
L
The base unit AC adaptor is not connected. Check
the connections.
L
You are using the handset or base unit in an area
with high electrical interference. Place the handset
and base unit away from interference sources,
such as antennas and mobile phones.
The handset display is
blank.
L
The handset is not turned on. Turn the power on
(page 11).
The handset will not
turn on.
L
Make sure that the batteries are installed correctly
(page 9).
L
Fully charge the batteries (page 10).
L
Clean the charge contacts and charge again (page
10).
I have changed the
display language to a
language I cannot
read.
L
Change the display language (page 11).
I cannot make or
receive calls.
L
The base unit AC adaptor or telephone line cord is
not connected. Check the connections.
L
If you are using a splitter to connect the unit,
remove the splitter and connect the unit to the wall
socket directly. If the unit operates properly, check
the splitter.
L
Disconnect the base unit from the telephone line
and connect the line to a known working telephone.
If the working telephone operates properly, contact
our service personnel to have the unit repaired. If
the working telephone does not operate properly,
contact your service provider/telephone company.
L
The dialling mode setting is incorrect. Set to
“
Tone
”
or
“
Pulse
”
as needed (page 11).
L
The key lock feature is turned on. Turn it off (page
14).
The unit does not ring.
L
The ringer volume is turned off. Adjust the ringer
volume (page 17, 17, 19).
TG7200-7220TW(e-e).book Page 36 Wednesday, April 25, 2007 4:49 PM