– 5 –
Frequently asked questions
Question
Cause/solution
Why is
w
flashing?
L
The handset is too far from the base unit. Move
closer.
L
The base unit’s AC adaptor is not properly
connected. Reconnect AC adaptor to the base
unit.
L
You are using the handset or base unit in an area
with high electrical interference. Re-position the
base unit and use the handset away from sources
of interference.
L
The handset is not registered to the base unit.
Register it (page 7).
Why can I not make calls?
L
The dialling mode may be set incorrectly. Change
the setting (page 3).
What should I do when the
handset does not turn on?
L
Make sure the batteries are installed correctly.
L
Fully charge the batteries.
L
Clean the charge contacts and charge again.
How long is the battery
operating time?
L
When you are using fully-charged Ni-MH batteries
(supplied batteries);
In continuous use: 17 hours max.
Not in use (standby): 180 hours max.
L
It is normal for batteries not to reach full capacity
at the initial charge. Maximum battery
performance is reached after a few complete
cycles of charge/discharge (use).
L
Actual battery performance depends on a
combination of how often the handset is in use
and how often it is not in use (standby).
Can I keep the handset on
the base unit or charger
when I am not using it?
L
Even after the handset is fully charged, the
handset can be left on the base unit or charger
without any ill effect on the batteries.
When should I replace the
batteries?
L
If the batteries are fully charged until
1
is
displayed, but
3
is displayed after a few calls,
replace the batteries with new ones.
What is a PIN?
L
The PIN is a 4-digit number that must be entered
in order to change certain base unit settings. The
default PIN is
“
0000
”
.
TG6481FX(e)_QG.fm Page 5 Friday, June 5, 2009 4:49 PM
