Problem
Cause/solution
I cannot operate the answering
system remotely.
R
The remote access code is not set. Set the remote
access code (page 24).
R
You are entering the wrong remote access code. If you
have forgotten your remote access code, enter the
remote access code setting to check your current code
(page 24).
R
The answering system is turned off. Turn it on (page 25).
Liquid damage
Problem
Cause/solution
Liquid or other form of moisture
has entered the handset/base
unit.
R
Disconnect the AC adaptor and telephone line cord from
the base unit. Remove the batteries from the handset and
leave to dry for at least 3 days. After the handset/base
unit are completely dry, reconnect the AC adaptor and
telephone line cord. Insert the batteries and charge fully
before use. If the unit does not work properly, contact an
authorized service centre.
Caution:
R
To avoid permanent damage, do not use a microwave oven to speed up the drying process.
Registering a handset to the base unit
1
Handset:
M
MENU
N
2
MbN
:
“
Initial setting
”
a
M
OK
N
3
MbN
:
“
Registration
”
a
M
OK
N
4
MbN
:
“
HS registration
”
a
M
OK
N
5
Base unit:
Press and hold
M
LOCATOR
N
for about 5 seconds until the registration tone sounds.
R
If all registered handsets start ringing, press
M
LOCATOR
N
again to stop, then repeat this
step.
R
The next step must be completed within 90 seconds.
6
Handset:
Press
M
OK
N
, then wait until a long beep sounds.
Note:
R
While registering,
“
Base in registering mode
”
is displayed on all registered handsets.
Deregistering a handset
1
M
MENU
N
2
MbN
:
“
Initial setting
”
a
M
OK
N
3
MbN
:
“
Registration
”
a
M
OK
N
4
MbN
:
“
Deregistration
”
a
M
OK
N
34
Useful Information
TG422xC(en)_0122_ver011.pdf 34
2013/01/22 11:22:42
