60
Before Requesting Help
Problem
You cannot program items,
such as the dialing mode.
Previously programmed
information is erased.
You cannot store a name
and phone number in the
directory.
While programming or
searching, the unit starts to
ring and stops the program/
search.
The unit does not display the
caller’s name and/or phone
number.
The display goes to the
standby mode while viewing
the Caller List.
When a second call is
received during a
conversation, the unit does
not display the new caller’s
name and/or phone number.
Remedy
•
Programming is not possible while the unit
is in the talk or speakerphone mode or
when viewing the Caller List/directory list.
•
Do not pause for over 60 seconds while
programming.
•
Move closer to the base unit.
•
Make sure that the unit is in the standby
mode.
•
If a power failure occurs, programmed
information may be erased. Reprogram
if necessary.
•
You cannot store an item in the directory
while the unit is in the talk,
speakerphone or intercom mode.
•
Do not pause for over 60 seconds while
storing.
•
To answer the call, press
(TALK)
or
(DIGITAL!SP-PHONE)
. Start again from
the beginning after hanging up.
•
You need to subscribe to a Caller ID
service from a telephone company.
•
Other telephone equipment may be
interfering with your phone. Disconnect
it and try again.
•
Other electrical appliances connected to
the same outlet may be interfering with
the Caller ID information.
•
Telephone line noise may be affecting
the Caller ID information.
•
Do not pause for over 60 seconds while
searching.
•
(DIGITAL!SP-PHONE)
was pressed.
•
The line mode selection is incorrect. See
page 16.
