76
Before Requesting Help
Problem
The unit does not display the
caller’s name and/or phone
number.
The handset display goes to
the standby mode while
viewing the Caller List.
When a second call is
received during a
conversation, the unit does
not display the new caller’s
name and/or phone number.
(LOCATOR/INTERCOM)
does
not function.
You cannot redial by
pressing
(REDIAL/PAUSE)
.
Remedy
•
You need to subscribe to a Call Display
service from a telephone company.
•
Other telephone equipment may be
interfering with your phone. Disconnect
it and try again.
•
Other electrical appliances connected to
the same outlet may be interfering with
the Call Display information.
•
Telephone line noise may be affecting
the Call Display information.
•
Do not pause for over 60 seconds while
searching.
•
The line mode selection is incorrect. See
page 17.
•
The handset is too far from the base unit.
•
The handset is engaged in an outside
call, viewing the Caller List/directory list
or listening to messages. Wait until the
IN USE/CHARGE indicator light goes
out.
•
If the last number dialed was more than
32 digits long, the number will not be
redialed correctly.
•
Access numbers entered after pressing
(TONE)
will not be included when
redialing.
•
The button has a double function as
either redial or pause. It will redial the
last number dialed if pressed at the
outset of a call (p. 29). If another
number has been dialed first, it will
operate as a pause button (p. 52).
