Main menu: “
Key detector
”
Sub-menu 1
Sub-menu 2
Settings
Code
Unit
Search
–
–
#655
–
Battery check
–
–
*1 If you program these settings using one of the units, you do not need to program the same item using
another unit.
*2 This menu is not displayed when scrolling through the display menus. It is only available in direct
command code.
*3 When the cellular line only mode is turned on, these menus are not displayed (page 18).
*4 After the Bluetooth device is paired, the device name is displayed.
*5 For CELL 1
*6 For CELL 2
*7 The preset melodies in this product (
“
Tone 3
”
-
“
Melody 10
”
) are used with permission of © 2009
Copyrights Vision Inc.
*8 The preset melodies in this product (
“
Tone 1
”
and
“
Tone 2
”
) are used with permission of © 2013
Copyrights Vision Inc.
*9 This feature allows the unit to automatically adjust the date and time each time caller information
including date and time is received.
To turn this feature on, select
“
Caller ID auto
”
. To turn this feature off, select
“
Manual
”
. (Caller
ID subscribers only)
To use this feature, set the date and time first (page 15).
*10 If you subscribe to a distinctive ring service, select a tone (tone 1 or 2). If you select a melody, you
cannot distinguish lines by their ringers.
*11 This tone lets you know when you receive an outside call while you are on another line or an
intercom call. If you select
“
On
”
, the tone sounds 2 times.
*12 This setting is available when you have the key detector (KX-TGA20). Read the installation manual
for more information on the key detector.
*13 For models with supplied key detectors, the display shows
“
1:Detector1
”
.
*14 If you register 2 or more key detectors.
*15 Handset
*16 Base unit
*17 If you subscribe to a Caller ID service and want to view the caller’s information after lifting up the
handset to answer a call, turn off this feature.
*18 The flash time depends on your telephone exchange or host PBX. Contact your PBX supplier if
necessary.
*19 Generally, the line mode setting should not be changed. This setting automatically maintains receiver
volume at the proper level depending on the current telephone line condition. Set the line mode to
“
A
”
if telephone line condition is not good.
44
For assistance, visit www.panasonic.ca/english/support
Programming
TG153CSK(en)_0422_ver021.pdf 44
2016/04/22 14:54:43
