Panasonic KX-TCA151AXM, Руководство по обслуживанию

Страница: 57 / 121

11 CHECK PROCEDURE (BASE UNIT)
11.1. Preparation
11.1.1. Equipment Required
• • • •
DECT tester: Rohde & Schwarz, CMD 60 is recommended.
• • • •
Frequency counter: it must be precise to be able to measure 1Hz (precision; ± 4ppm).
Hewlett Packard, 53131A is recommended.
•
• •
•
DC power: it must be able to output at least 1A current under 9V.
•
• •
•
Digital multi-meter (DMM): it must be able to measure voltage and current.
•
• •
•
Oscilloscope
11.1.2. JIG and PC
• • • •
EEPROM serial JIG
JIG Cable: PQZZ1CD505E
• • • •
PC which runs in DOS mode
• • • •
Batch file for setting: PQZZTCD530AX
11.2. PC Setting
11.2.1. Connections
11.2.2. PC Setting
1. Open a window of MS-DOS mode from the start-up menu.
2. Change a directory.
3. Type “SET_COM 1” from the keyboard (when COM port 1 is used for the connection).
4. Type “doskey”.
Note:
See the table below for frequently used commands.
Command name Function Example
rdeeprom Read the data of EEPROM Type “rdeeprom 00 00 FF”, and the data from
address “00 00” to “FF” is read out.
readid Read ID (RFPI) Type “readid”, and the registered ID is read out.
writeid Write ID (RFPI) Type “writeid 00 18 E0 0E 98”, and the ID “0018 E0 0E
98” is written.
setfreq adjust Frequency of RFIC Type “setfreq nn”.
hookoff off-hook mode on Base Type “sethooksw 01”.
hookon on-hook mode on Base Type “sethooksw 00”.
Getchk Read checksum Type “getchk”.
Wreeprom write eeprom Type "wreeprom 01 23 45". "01 23" is address and "45"
is data to be written.
For Service Hint:
Please make sure the speed of COM port is “9,600 bps” or less.
57
KX-TCD530AXM / KX-TCA151AXM