Panasonic KX-TC2000SNB, Руководство по обслуживанию

Страница: 27 / 81

Adjustment
Items
Test
Mode
Adjustment
Point
Procedure
(A
)
Battery Low
Confirmation
3ch
Talk -
1. Apply 3.50V between BATT(+) and BATT(-).
2. Confirm that there is no flashing of RECHARGE LED.
3. Apply 3.40V between BATT(+) and BATT(-).
4. Confirm that there is flashing of RECHARGE LED.
(B
)
TX VCO
Adjustment
3ch
Talk T6
1. Adjust T6 so that the reading of the Digital Voltmeter is 1.5V ± 0.2V.
(C
)
RX VCO
Confirmation
3ch
Talk -
1. Set S2 to RX VCO side.
2. The reading of the Digital Voltmeter is 0.8V ~ 3.0V.
(After adjusting, set S2 to OFF).
(D
)
TX Frequency
Adjustment
3ch
Talk VC1
-
Confirm so that the reading of the frequency counter is 49.860MHz ± 100Hz.
(E
)
TX Power
Confirmation
3ch
Talk -
-
Confirm output level should be over -2dBm on RF VTVM (50 load).
(F) RX
Sensitivity
Confirmation
(2nd IF
output)
3ch
Talk T3
1. Apply -60dBm output from S.S.G. (modulation frequency 1KHz, dev. 0KHz).
2. Confirm 2nd IF output so that the reading of RF VTVM is more than 15mV.
(G
)
Noise
Squelch
Confirmation
3ch
Talk -
1. Measure the SSG output level when the noise squelch changes from Low to
High. (modulation frequency 1KHz, dev.3kHz)
2. Confirm that the SSG output level is -105dBm.
(H
)
Speaker
Output Level
Confirmation
3ch
Talk -
1. Apply -60dBm output from S.S.G. (modulation frequency 1KHz, dev. 3KHz).
2. Confirm that SP output level is more than 60mV.
(distortion: less than 5%) (volume High).
(I) Mic
Modulation
Factor
Confirmation
3ch
Talk -
1. Apply a MIC signal (1KHz, 2.4mV at 600 load).
2. Confirmation so that the reading FM Deviation Meter is 2.0KHz ± 0.5KHz.
(J) Data
Modulation
Confirmation
3ch
Talk -
-
Confirm for 4.0KHz ~ 6.0KHz FM Deviation Meter reading.
The connections of adjustment equipment are as shown in Adjustment Standard (Handset) ().
SSG Frequency: 46.670 MHz
12.4. Adjustment Standard (Handset)
When connecting the Simulator and Equipments for checking, please refer to the illustration
below.
(Component View)
27